Features of your vehicle
Windows
Power windows (if equipped)
Window opening and closing
The ignition switch must be in the ON
The driver’s door has a master power
position for power windows to operate.
window switch that controls all the win-
dows in the vehicle.
Each door has a power window switch
that controls the door's window. The
Up/down window
driver has a power window lock switch
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 30
seconds after the ignition key is
removed or turned to the ACC or LOCK
position. However, if the front doors
OJAPE033009R
open, the power windows cannot be
To open or close a window, press down
operated within the 30 second period
or pull up the front portion of the corre-
after ignition key removal (if equipped).
sponding switch to the first detent posi-
If the window cannot be close because it
tion (5).
is blocked by objects, remove the
Auto up/down window (if
objects and close the window.
equipped)
NOTICE
Whilst driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open) position, your
vehicle may demonstrate a wind buffet-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
OJAPE033008R
or eliminated by taking the following
Pressing or pulling up the power window
actions. If the noise occurs with one or
switch momentarily to the second detent
both of the rear windows down, partially
position (6) completely lowers or lifts the
lower both front windows approximately
window even when the switch is
one inch. If you experience the noise
released. To stop the window at the
with the sunroof open, slightly reduce
desired position whilst the window is in
the size of the sunroof opening.
operation, pull up or press and release
the switch to the opposite direction of
the movement.
WARNING
If the power window is not operated cor-
Do not install any accessories in the area
rectly, the automatic power window sys-
of windows. It may impact jam protec-
tem must be reset as follows:
tion.
1. Turn the ignition switch to the ON
position.
2. Close the window and continue pull-
ing up window switch for at least 1
4
22