101
2
2-1. Instrument cluster
Vehicle status information and indicators
Indicator does not operate.
● “READY” indicator is not illuminated.
● The shift position is in other than D or S.
■ Changing between the tachometer or
hybrid system indicator
Depending on the current drive mode or
settings, the displays will change as follows.
Settings can be changed on the Center Dis-
play. (P.556)
● The tachometer will be displayed in the
following situations.
• When the meter display type setting is set
to display type 1 or display type 3
• When the tachometer setting is set to
always display the tachometer
• When the tachometer setting is set to
change according to the driving mode
and a driving mode other than Eco drive
mode is selected
● The hybrid system indicator will be dis-
played in the following situations.
• When the meter display type setting is set
to display type 1 or display type 3
• When the tachometer setting is set to
always display the hybrid system indica-
tor
• When the tachometer setting is set to
change according to the driving mode
and Eco drive mode is selected
■ Outside temperature display
● In the following situations, the correct
outside temperature may not be dis-
played, or the display may take longer
than normal to change:
• When stopped, or driving at low speeds
(less than 20 km/h [12 mph])
• When the outside temperature has
changed suddenly (at the entrance/exit
of a garage, tunnel, etc.)
● When “--” or “E” is displayed, the system
may be malfunctioning. Take your vehicle
to any authorized Lexus retailer or Lexus
authorized repairer, or any reliable
repairer.
■ Liquid crystal display
Small spots or light spots may appear on the
display. This phenomenon is characteristic
of liquid crystal displays, and there is no
problem continuing to use the display.
■ Free/Open Source Software Informa-
tion
This product contains Free/Open Source
Software (FOSS). The license information
and/or the source code of such FOSS can
be found at the following URL.
https://www.denso.com/global/en/
opensource/meter/toyota/
■ The information display at low tem-
peratures
Allow the interior of the vehicle to warm
up before using the liquid crystal infor-
mation display. At extremely low tem-
peratures, the information display
monitor may respond slowly, and display
changes may be delayed.
For example, there is a lag between the
driver’s shifting and the new gear num-
ber appearing on the display. This lag
could cause the driver to downshift
again, causing rapid and excessive
engine braking and possibly an accident
resulting in death or injury.
■ To prevent damage to the engine and
its components
● Do not let the indicator needle of the
tachometer enter the red zone, which
indicates the maximum engine speed.
● The engine may be overheating if the
engine coolant temperature gauge is
in the red zone (H); or “Engine Coo-
lant Temp High Stop in a Safe Place
See Owner’s Manual” is shown on the
multi-information display. In this case,
immediately stop the vehicle in a safe
place, and check the engine after it has
cooled completely. (P.539)