2013-2016 Mazda Cx-5 SUV Owner Maintenance -> Key Battery Replacement User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Owner Maintenance -> Key Battery Replacement for Your Mazda Cx-5 SUV First Generation (2013-2016)

Maintenance and Care  
Owner Maintenance  
l
l
The system does not operate and the  
operation indicator light on the  
transmitter does not flash when the  
buttons are pressed.  
The system's operational range is  
reduced.  
Key Battery Replacement  
If the buttons on the transmitter are  
inoperable and the operation indicator  
light does not flash, the battery may be  
dead.  
Replacing the battery at an Authorized  
Mazda Dealer is recommended to prevent  
damage to the key. If replacing the battery  
by yourself, follow the instruction below.  
Replace with a new battery before the  
transmitter becomes unusable.  
CAUTION  
Replacing the key battery  
Ø Make sure the battery is installed  
correctly. Battery leakage could  
occur if it is not installed correctly.  
Ø When replacing the battery, be  
careful not to touch any of the  
internal circuitry and electrical  
terminals, bend the electrical  
terminals, or get dirt in the  
transmitter as the transmitter  
could be damaged.  
1. Press the knob and pull out the  
auxiliary key.  
Knob  
Ø There is the danger of explosion if  
the battery is not correctly  
replaced.  
Ø Dispose of used batteries  
according to the following  
instructions.  
Ø
2. Twist a tape-wrapped flathead  
screwdriver in the direction of the  
arrow and open the cover slightly.  
Insulate the plus and minus  
terminals of the battery using  
cellophane or equivalent tape.  
Never disassemble.  
Ø
Ø
Cover  
Never throw the battery into  
fire or water.  
Ø
Never deform or crush.  
Ø Replace only with the same type  
battery (CR2025 or equivalent).  
The following conditions indicate that the  
battery power is low:  
l
The KEY indicator light (green) flashes  
in the instrument cluster for about 30  
seconds after the engine is turned off  
(for vehicles with a type A meter,  
messages are displayed in the  
instrument cluster).  
6-40  
Maintenance and Care  
Owner Maintenance  
3. Insert the tape-wrapped flathead  
screwdriver into the gap and slide it in  
the direction of the arrow.  
5. Remove the battery cap, then remove  
the battery.  
Cover  
Gap  
6. Insert a new battery with the positive  
pole facing up, and then cover the  
battery with the battery cap.  
4. Twist the flathead screwdriver in the  
direction of the arrow and remove the  
cover.  
Cover  
7. Close the cover.  
8. Reinsert the auxiliary key.  
6-41  

Related Topics

Popular Owner Manuals