2013-2016 Mazda Cx-5 SUV Owner Maintenance -> Tires User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Owner Maintenance -> Tires for Your Mazda Cx-5 SUV First Generation (2013-2016)

Maintenance and Care  
Owner Maintenance  
Tires  
CAUTION  
Ø Be careful not to allow the rubber  
ring shown in the figure to be  
scratched or damaged.  
Ø If the rubber ring detaches,  
reattach it before inserting a new  
battery.  
For reasons of proper performance, safety,  
and better fuel economy, always maintain  
recommended tire inflation pressures and  
stay within the recommended load limits  
and weight distribution.  
WARNING  
Using Different Tire Types:  
Driving your vehicle with different  
types of tires is dangerous. It could  
cause poor handling and poor  
braking; leading to loss of control.  
Except for the limited use of the  
temporary spare tire, use only the  
same type tires (radial, bias-belted,  
bias-type) on all four wheels.  
Rubber ring  
Using Wrong-Sized Tires:  
Using any other tire size than what is  
specified for your Mazda (page 9-8)  
is dangerous. It could seriously affect  
ride, handling, ground clearance, tire  
clearance, and speedometer  
calibration. This could cause you to  
have an accident. Use only tires that  
are the correct size specified for your  
Mazda.  
6-42  
Maintenance and Care  
Owner Maintenance  
NOTE  
l
qTire Inflation Pressure  
Always check tire pressure when tires are  
cold.  
WARNING  
Always inflate the tires to the correct  
pressure:  
l
l
Warm tires normally exceed recommended  
pressures. Do not release air from warm  
tires to adjust the pressure.  
Underinflation can cause reduced fuel  
economy, uneven and accelerated tire wear,  
and poor sealing of the tire bead, which  
will deform the wheel and cause separation  
of tire from rim.  
Overinflation or underinflation of  
tires is dangerous. Adverse handling  
or unexpected tire failure could result  
in a serious accident.  
Refer to Tires on page 9-8.  
l
Use only a Mazda-genuine tire valve  
cap:  
Overinflation can produce a harsh ride,  
uneven and accelerated tire wear, and a  
greater possibility of damage from road  
hazards.  
Keep your tire pressure at the correct  
levels. If one frequently needs inflating,  
have it inspected.  
Use of a non-genuine part is  
dangerous as the correct tire air  
pressure cannot be maintained if the  
tire valve becomes damaged. If the  
vehicle is driven under this condition,  
the tire air pressure will decrease  
which could result in a serious  
accident. Do not use any part for the  
tire valve cap that is not a Mazda-  
genuine part.  
qTire Rotation  
WARNING  
Rotate tires periodically:  
Irregular tire wear is dangerous. To  
equalize tread wear for maintaining  
good performance in handling and  
braking, rotate the tires according to  
the scheduled maintenance charts.  
Refer to Scheduled Maintenance on  
page 6-4.  
Inspect all tire pressures monthly  
(including the spare) when the tires are  
cold. Maintain recommended pressures  
for the best ride, handling, and minimum  
tire wear.  
Refer to the specification charts (page  
9-8).  
After adjusting the tire pressure,  
initialization of the tire pressure  
monitoring system is necessary to make  
the system operate normally.  
Refer to Tire Pressure Monitoring System  
Initialization on page 4-151.  
6-43  
Maintenance and Care  
Owner Maintenance  
During rotation, inspect them for correct  
balance.  
qReplacing a Tire  
WARNING  
Always use tires that are in good  
condition:  
Driving with worn tires is dangerous.  
Reduced braking, steering, and  
traction could result in an accident.  
Replace all four tires at the same time:  
Replacing just one tire is dangerous.  
It could cause poor handling and  
poor braking resulting in loss of  
vehicle control. Mazda strongly  
recommends that you replace all four  
tires at the same time.  
Forward  
Do not include (TEMPORARY USE ONLY)  
spare tire in rotation.  
Also, inspect them for uneven wear and  
damage. Abnormal wear is usually caused  
by one or a combination of the following:  
If a tire wears evenly, a wear indicator  
will appear as a solid band across the  
tread.  
l
Incorrect tire pressure  
Improper wheel alignment  
Out-of-balance wheel  
Severe braking  
l
Replace the tire when this happens.  
l
l
Tread wear indicator  
After rotation, inflate all tire pressures to  
specification (page 9-8) and inspect the  
lug nuts for tightness.  
After adjusting the tire pressure,  
initialization of the tire pressure  
monitoring system is necessary to make  
the system operates normally.  
Refer to Tire Pressure Monitoring System  
Initialization on page 4-151.  
New tread  
Worn tread  
You should replace the tire before the  
band crosses the entire tread.  
After adjusting the tire pressure,  
initialization of the tire pressure  
monitoring system is necessary to make  
the system operates normally.  
CAUTION  
Rotate unidirectional tires and radial  
tires that have an asymmetrical tread  
pattern or studs only from front to  
rear, not from side to side. Tire  
performance will be reduced if  
rotated from side to side.  
Refer to Tire Pressure Monitoring System  
Initialization on page 4-151.  
6-44  
Maintenance and Care  
Owner Maintenance  
NOTE  
CAUTION  
Tires degrade over time, even when they are  
not being used on the road. It is recommended  
that tires generally be replaced when they are  
6 years or older. Heat caused by hot climates  
or frequent high loading conditions can  
accelerate the aging process. You should  
replace the spare tire when you replace the  
other road tires due to the aging of the spare  
tire. The period in which the tire was  
manufactured (both week and year) is  
indicated by a 4-digit number.  
Ø Do not use your temporary spare  
tire rim with a snow tire or a  
conventional tire. Neither will  
properly fit and could damage  
both tire and rim.  
Ø The temporary spare tire has a  
tread life of less than 5,000 km  
(3,000 miles). The tread life may  
be shorter depending on driving  
conditions.  
Ø The temporary spare tire is for  
limited use, however, if the tread  
wear solid-band indicator  
appears, replace the tire with the  
same type of temporary spare  
(page 6-45).  
Refer to Tire Labeling on page 8-25.  
qTemporary Spare Tire  
Inspect the temporary spare tire at least  
monthly to make sure it is properly  
inflated and stored.  
NOTE  
NOTE  
Tires degrade over time, even when they are  
not being used on the road. It is recommended  
that tires generally be replaced when they are  
6 years or older. Heat caused by hot climates  
or frequent high loading conditions can  
accelerate the aging process. You should  
replace the spare tire when you replace the  
other road tires due to the aging of the spare  
tire. The period in which the tire was  
The temporary spare tire condition gradually  
deteriorates even if it has not been used.  
The temporary spare tire is easier to  
handle because of its construction which  
is lighter and smaller than a conventional  
tire. This tire should be used only for an  
emergency and only for a short distance.  
manufactured (both week and year) is  
indicated by a 4-digit number.  
Refer to Tire Labeling on page 8-25.  
Use the temporary spare tire only until the  
conventional tire is repaired, which should  
be as soon as possible.  
qReplacing a Wheel  
Refer to Tires on page 9-8.  
WARNING  
Always use wheels of the correct size  
on your vehicle:  
Using a wrong-sized wheel is  
dangerous. Braking and handling  
could be affected, leading to loss of  
control and an accident.  
6-45  
Maintenance and Care  
Owner Maintenance  
CAUTION  
A wrong-sized wheel may adversely  
affect:  
Ø Tire fit  
Ø Wheel and bearing life  
Ø Ground clearance  
Ø Snow-chain clearance  
Ø Speedometer calibration  
Ø Headlight aim  
Ø Bumper height  
Ø Tire Pressure Monitoring System  
NOTE  
l
When replacing a wheel, make sure the new  
one is the same as the original factory  
wheel in diameter, rim width, and offset  
(inset/outset).  
l
For details, contact an Authorized Mazda  
Dealer.  
Proper tire balancing provides the best  
riding comfort and helps reduce tread  
wear. Out-of-balance tires can cause  
vibration and uneven wear, such as  
cupping and flat spots.  
6-46  
MEMO  
6-47  

Related Topics

Popular Owner Manuals