Get Instruments and Controls -> Lights and Switches Guide for Mg Zs SUV First Generation (2017-2024)

INSTRUMENTS AND CONTROLS

Lights and Switches

Master Lighting Switch

AUTO Lamp

1

When the START/STOP Switch is in the ACC position, the

auto lighting system defaults to the ON position (1). The

auto lighting system will automatically switch the side lamps

and switch illumination on and off according to the intensity

of current ambient light.

With the START/STOP Switch switched to the ON

position, the auto lighting system defaults to the ON

position (1). The auto lighting system will automatically

switch the side lamps, switch illumination and dipped

headlamps on and off according to the intensity of current

ambient light.

Note: This function is realized by ﬁtting a sensor

capable of monitoring exterior lighting conditions

in real time on your vehicle. The sensor is ﬁtted in

the centre of the fascia panel near the windscreen

in some models. DO NOT mask or cover this area,

or headlamps may automatically go on when not

necessary.

1

2

3

4

AUTO Lamp

Side Lamps and Switch Illumination

Dipped Headlamps

Lights OFF

37

INSTRUMENTS AND CONTROLS

Side lamps and Switch Illumination

headlamps and side lamps will illuminate depending upon

the vehicle conﬁguration. It can be set in the ‘Comfort and

Convenience’ in the Vehicle Settings on the entertainment

display.

Turn the master lighting switch to position 2 to operate the

side lamps and switch illumination. With the START/STOP

Switch in the OFF position if the lighting switch is in

position 2 and the driver’s door opened an audible warning

will sound to alert the driver, the side lamps will remain

on.

Daytime Running Lamp

The daytime running lamps turn on automatically when

the START/STOP Switch is in the ON position. When

the side lamps are switched on, the daytime running lamps

extinguish automatically.

Dipped Headlamps

When the START/STOP Switch is in the ON position, turn

the master lighting switch to position 3 to operate the

dipped headlamps and side lamps.

Find My Car

After the vehicle has been left in a locked condition for a

few minutes pressing the lock button again on the remote

key will enable the Find My Car function. This function

will identify the car by means of an audible and visual alert.

Pressing the Lock button on the handset again will suspend

this operation. Pressing the Unlock button will cancel

this operation. This feature can be set via ‘Comfort and

Convenience’ in the Vehicle Settings on the entertainment

display.

Lights Off

Turn the master lighting switch to position 4, this will

switch off all lamps, releasing the switch will allow it to

return to the AUTO switch position.

Follow Me Home

After the START/STOP Switch is turned off, pull the

lighting stalk switch towards the steering wheel. This

will enable the Follow Me Home function, dipped beam

38

INSTRUMENTS AND CONTROLS

Headlamp Levelling Manual Adjustment

Location

Load

1

0

1

Driver, or driver & front passenger.

All the seats occupied with no load.

All the seats occupied plus an evenly

distributed load in the boot, or driver with

full load.

2

3

Driver only, plus an evenly distributed load in

the boot.

Position 0 is the initial position of the headlamp levelling

adjustment switch. The headlamp levelling adjustment can

be made as per the following table according to the vehicle

load.

39

INSTRUMENTS AND CONTROLS

Fog Lamp Switch

will turn on the front fog lamps. The indicator illuminates

in the instrument panel when the front fog lamps are on.

Fog lights should only be used when visibility

is below 100m - other road users could be

dazzled in clear conditions.

Rear Fog Lamp

With the START/STOP Switch in the ON position and the

headlamps or front fog lamps on, turn the fog lamp switch

to position 2, this will turn on the rear fog lamp, release

the switch to allow it to return to the last position. The

indicator illuminates in the instrument panel when the rear

fog lamp is on.

*

Front Fog Lamps

With the START/STOP Switch in the ON position and the

side lamps on, turn the fog lamp switch to position 1, this

40

INSTRUMENTS AND CONTROLS

Direction Indicator/Main Beam Switch

GREEN indicator lamp in the instrument pack will ﬂash

when the turning signal lamps are working.

1

Take care not to dazzle oncoming vehicles

when driving using main beam headlamps.

Rotating the steering wheel will cancel the indicator

operation (small movements of the steering wheel may

not operate the self cancelling). To indicate a lane change,

move the lever brieﬂy and release, the indicators will ﬂash

three times and then cancel.

Headlamp High/Low Beam Switching

With the START/STOP Switch in the ON position and the

master lighting switch turned to position 3, or the auto

function has switched the lights on, push the lever (3)

towards the instrument panel to turn on headlamp high

beams. The high beam indicator lamp in instrument pack

illuminates, press the lever (3) again to switch to headlamp

low beams.

High Beam Flash

Direction Indicators

To brieﬂy ﬂash the high beam on and off, pull the lever

towards the steering wheel (4) and then release.

Move the lever down to indicate a LEFT turn (1). Move the

lever up to indicate a RIGHT turn (2). The corresponding

41

INSTRUMENTS AND CONTROLS

Hazard Warning Lamp

Press the hazard warning lamp button

to turn on

the hazard warning lamps. The turning signal lamps and

direction indicator lamps will ﬂash together. Press the

button again to switch off the hazard warning lamps. All

turning signal lamps and direction indicator lamps will stop

ﬂashing. For more details and location refer to 'Emergency

Information' 'Hazard Warning Devices'.

42

Instruments and Controls -> Lights and Switches for Your Mg Zs SUV First Generation (2017-2024)

Related Topics

Popular Owner Manuals

Latest Owner Manuals