2017-2024 Mg Zs SUV Instruments and Controls -> Wipers and Washers User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Instruments and Controls -> Wipers and Washers for Your Mg Zs SUV First Generation (2017-2024)

INSTRUMENTS AND CONTROLS  
Wipers and Washers  
•
•
•
Fast wipe (3)  
1
Single wipe (4)  
*
Automatic wipe interval adjustment / Rain sensor  
sensitivity adjustment (5)  
*
•
Programmed wash/wipe (6)  
Intermittent Wipe  
By pushing the lever up to the Intermittent wipe position  
(1), the wipers will operate automatically. Turn the switch  
(5) * to adjust the intermittent wipe frequency. This speed  
will also change with the vehicle speed. As the vehicle  
speed increases, the wiper frequency increases. As the  
vehicle speed decreases, the wiper frequency decreases.  
Some models are equipped with a rain sensor fitted to the  
interior rear view mirror base to detect varying amounts  
of water on the outside of the windscreen. With automatic  
wipe, the vehicle will adjust the wiping speed according to  
the signals provided by rain sensor. Turn the switch (5)  
to adjust the sensitivity of rain sensor. As the sensitivity  
increases, the wiping interval decreases.  
Windscreen Wiper Operation  
The wipers and washers will only operate with the  
START/STOP Switch in the ACC/ON/RUNNING position.  
Operate the lever to select different wipe speeds:  
Note: Immediately operating the wiper one time can  
be achieved by increasing the sensitivity of rain sensor.  
•
•
Intermittent wipe (1)  
Slow wipe (2)  
43  
INSTRUMENTS AND CONTROLS  
If the rain sensor detects a continuous rainwater, the  
wiper will keep working. When no rain is detected, it  
is recommended to switch off automatic wipe.  
IMPORTANT  
•
•
Avoid operating the wiper on a dry windscreen.  
In freezing or extremely hot weather conditions,  
make sure that the wiper blades are not  
frozen/adhered to the windscreen.  
Slow Wipe  
By pushing the lever up to the slow wipe position (2), the  
wipers will operate slowly. Move the lever to re-select the  
wipe speed.  
•
In winter, remove snow or ice from around the arms  
and blades, including the wiped area of the screen.  
Fast Wipe  
Programmed Wash/Wipe  
By pushing the lever up to the fast wipe position (3), the  
wipers will operate fast. Move the lever to re-select the  
wipe speed.  
Pulling the lever toward the steering wheel (6) will operate  
the windscreen washers. After a short delay, the wipers  
will commence operating in conjunction with the washers.  
Note: The wipers continue operating for a further  
three wipes after the lever is released. After several  
seconds, there will be a further wipe to remove any  
fluid draining down the screen.  
Single Wipe  
Pressing the lever (4) down and releasing will operate  
a single wipe, if the lever is held down, the wipers will  
operate until the lever is released.  
Note: When the car is stationary, if the bonnet  
is opened, the front wiper/washer will stop work  
immediately.  
44  
INSTRUMENTS AND CONTROLS  
Rear Window Wiper Operation  
IMPORTANT  
1
If the washers fail to deliver the screen wash solution  
(dirt or ice may have blocked the jets), release the  
lever immediately.  
This will prevent the wipers  
from operating, and the consequent risk of visibility  
being impaired by dirt smearing across the unwashed  
windscreen.  
•
•
•
•
Intermittent wipe (1)  
Wash and wipe (2)  
Wash and wipe (3)  
Intermittent wipe frequency adjustment (4)  
The rear window wiper and washer will only operate  
with the START/STOP Switch in the ACC/ON/RUNNING  
position.  
Turn the rear window wiper switch to  
intermittent wipe (1), the rear window wiper will operate,  
45  
INSTRUMENTS AND CONTROLS  
after 3 consecutive wipes, the wipers will enter into  
intermittent mode. The time period between the wipes  
can be increased/decreased via the intermittent wipe  
frequency adjustment switch (4).  
Note: When the windscreen wipers are switched on, if  
the shift control lever is moved to, or in the R position,  
the rear window wiper will operate.  
Turn the rear window wiper switch to wash and wipe (2)  
position and hold, the rear window wiper and washer will  
operate, the rear window wiper wipes quickly. release the  
switch allowing it to return to intermittent wipe (1), the  
rear window washer will stop operating, and the wiper  
wipes slowly, change the stalk switch position 4 to adjust  
the wipe speed.  
Turn the rear window wiper switch to wash and wipe (3)  
and hold, the rear window wiper and washer will operate.  
release the switch allowing it to return to OFF position,  
the rear window washer will stop operating, and the rear  
window wiper wipes for 3 times, after several seconds, the  
wiper will wipe once more to remove the washer fluid on  
the windscreen.  
Note: When the tailgate is opened, rear window wiper  
operations will be disabled.  
46  

Related Topics

Instruments and Controls
Instruments and Controls Instrument Pack Information Centre Warning Lights and Indicators Lights and Switches Steering System Horn Mirrors Sunvisor Windows Sunroof Interior Lights Power Socket Storage Devices Cup Holder Roof Luggage Rack

Popular Owner Manuals

Audi
Audi
BMW
BMW
Citroen
Citroen
Ford
Ford
Honda
Honda
Peugeot
Peugeot