may not work. Malfunctioning stop lights could
cause an accident injuring yourself and others.
periods of time with the overdrive in the “OFF”
position. This reduces fuel economy.
the transmission to return to normal operation,
or have it repaired if necessary.
High fluid temperature protection mode
Overdrive switch (if equipped)
DRIVING WITH MANUAL TRANSMISSION
(MT)
This transmission has a high fluid temperature protec-
tion mode. If the fluid temperature becomes too high
(for example, when climbing steep grades in high
temperature with heavy loads, such as when towing a
trailer), engine power and, under some conditions,
vehicle speed will be decreased automatically to
reduce the chance of transmission damage. Vehicle
speed can be controlled with the accelerator pedal,
but engine and vehicle speed may be limited.
WARNING:
.
.
Do not downshift abruptly on slippery roads.
This may cause a loss of control.
Do not over-rev the engine when shifting to
a
lower gear. This may cause
a
loss of
control or engine damage.
Fail-safe
CAUTION:
SSD1180
When the fail-safe operation occurs, the CVT will not
be shifted to the selected driving position.
.
Do not rest your foot on the clutch pedal
while driving. This may damage the clutch
system.
To select the overdrive “OFF” position, push the
overdrive switch with the shift lever in the “D” (Drive)
If the vehicle is driven under extreme conditions,
such as excessive wheel spinning and subse-
quent hard braking, the fail-safe system may be
activated. This will occur even if all electrical
circuits are functioning properly. In this case,
place the ignition switch in the “OFF” position
and wait for 10 seconds. Then turn the ignition
switch back to the “ON” position. The vehicle
should return to its normal operating condition.
If it does not return to its normal operating
position. The overdrive indicator light
in the meter
.
.
.
Fully depress the clutch pedal before shift-
ing to help prevent transmission damage.
panel illuminates. To select the overdrive “ON”
position, push the overdrive switch again. The overd-
rive indicator light will turn off. When the shift lever is
shifted to any position other than “D”, the overdrive will
be automatically “ON” position.
Stop your vehicle completely before shifting
into “R” (Reverse) position.
When the vehicle is stopped for a period of
time, for example waiting at stoplights, shift
to the “N” (Neutral) position and release the
clutch pedal with the foot brake pedal
depressed.
“ON” position:
For normal driving and fuel economy, use the “ON”
position.
condition, have
transmission and repair it if necessary.
a
NISSAN dealer check the
“OFF” position:
Starting vehicle
For driving up or down long slopes where engine
braking is necessary, or for powerful acceleration, use
the “OFF” position. The transmission will automatically
select a different gear ratio, allowing the engine to
provide high output.
WARNING:
1. After starting the engine, depress the clutch pedal
to the floor and move the shift lever to the “1” (1st)
or “R” (Reverse) position.
When the fail-safe operation occurs, vehicle
speed may be gradually reduced. The reduced
speed may be lower than other traffic, which
could increase the chance of a collision. Be
especially careful when driving. If necessary, pull
to the side of the road at a safe place and allow
2. Slowly depress the accelerator pedal, releasing
the clutch pedal and parking brake at the same
time.
When driving conditions change, push the switch to
the overdrive “ON” position.
Remember not to drive at high speeds for extended
5-14 Starting and driving
English 
