[ Edit: 2014/ 11/ 7 Model: T32-A ]
3. Push the back door up to open.
Contact a NISSAN dealer as soon as possible for
repair.
GARAGE MODE SYSTEM
GUID-531CA4F1-7D23-438C-A1F3-4CA23C52B39B
The back door can be set to open to a specific height
by performing the following:
1. Open the back door using the request switch or
the Intelligent Key.
2. Pull the back door down to the desired position
and hold the back door (the back door will have
some resistance when being manually adjusted).
3. While holding the back door in position, press and
hold the back door switch
*
D
located on the
back door for approximately 3 seconds or until 2
beeps are heard.
The back door will open to the selected position
setting. To change the position of the back door,
repeat steps 1-3 for setting the position of the back
door.
CAUTION:
Do not set the height of the back door below
approximately 1/3 of the way to the floor using
garage mode. Even if you set the height below
approximately 1/3 of the way to the floor, the
height will automatically be set to approximately
1/3 of the way to the floor.
T32A130827-F6C771EA-041B-45A2-BC6E-E70D9FACF7EA
WARNING:
. Fuel is extremely flammable and highly
explosive under certain conditions. You
could be burned or seriously injured if it is
misused or mishandled. Always stop the
engine and do not smoke or allow open
flames or sparks near the vehicle when
refueling.
. Fuel may be under pressure. Turn the cap a
half of a turn, and wait for any “hissing”
sound to stop to prevent fuel from spraying
out and possibly causing personal injury.
Then remove the cap.
. Use only an original equipment type fuel
filler cap as a replacement. It has a built-in
safety valve needed for proper operation of
the fuel system and emission control sys-
tem. An incorrect cap can result in a serious
malfunction and possible injury.
OPENING FUEL FILLER LID
T32A130827-0D460FB6-261C-4E00-B4CB-E4FF034DD8D4
SPA2336
To open the fuel filler lid, pull the fuel filler lid release
handle.
FUEL FILLER CAP
T32A130827-5BDD6661-9721-413B-9229-2776A0BD46DC
SPA2800
The fuel filler cap is a ratcheting type. Turn the cap
counterclockwise
*
1
to remove. Tighten the cap
clockwise
*
2
until ratchet clicks, more than twice,
after refueling.
Put the fuel filler cap on the cap holder
*
A
while
refueling.
CAUTION:
If fuel is spilled on the vehicle body, flush it away
with water to avoid paint damage.
Pre-driving checks and adjustments 3-27
FUEL FILLER LID
Condition: 'Except for China'/
English 
