Practical Information -> Economy Mode Function for Your Peugeot 1007 4 Door First Generation (2005-2009)

9
CHANGING A WINDSCREEN  
WIPER BLADE  
ECONOMY MODE FUNCTION  
After the engine has stopped, certain  
functions (doors, windscreen wipers,  
electric windows, courtesy light, audio  
equipment, dipped headlamps, etc.)  
can only be used for a cumulative  
duration of thirty minutes, to prevent  
discharging of the battery.  
Once the thirty minutes are over, a  
message informing you of the switch  
to economy mode appears on the  
multifunction display and the active  
functions are put on standby.  
Placing the wiper blades in the  
special position  
Less than a minute after switch-  
ing off the ignition, operate the  
wipers stalk to position the wiper  
blades in the centre of the wind-  
screen.  
Changing a front wiper blade  
Lift the wiper arm.  
These functions are reactivated auto-  
matically next time the vehicle is driven.  
To resume the use of these functions  
immediately, start the engine and let  
it run for a few minutes.  
The time available to you will then be  
double the duration for which the en-  
gine is left running. However, this pe-  
riod will always be between five and  
thirty minutes.  
Note: if the telephone is being used  
when economy mode starts, it will  
still be possible to finish the call.  
FITTING/REMOVING THE MAT  
Unclip the blade and remove it.  
Fit the new blade.  
Push back the wiper arm.  
When removing the mat on the driv-  
er’s side, push the seat as far back  
as possible and remove the fixings.  
When refitting, position the mat cor-  
rectly on the pins and clip the fixings.  
Check that the mat is secured cor-  
rectly.  
Note: the shortest blade is fitted on  
the right-hand wiper arm.  
To prevent the mat from becoming  
caught under the pedals:  
To return the windscreen wipers  
to their normal position, switch on  
the ignition and operate the wipꢀ  
ers stalk.  
-
only use mats suited to the fix-  
ings already present in the ve-  
hicle. It is imperative that these  
fixings are used.  
Changing the rear wiper blade  
-
never fit one mat on top of an-  
other.  
Lift the wiper arm.  
Unclip the blade and remove it.  
Fit the new blade.  
Push back the wiper arm.  
A flat battery will prevent the  
engine from starting.  
127