Practical Information -> Rear Lights for Your Peugeot 1007 4 Door First Generation (2005-2009)

9
Remove the bulb holder moving  
aside the two tabs A,  
Turn the bulb a quarter of a turn,  
Remove the bulb and change it.  
Rear lights  
1. Brake/side lights  
(P21 W/5 W).  
2. Direction indicators  
(P21 W).  
3. Reversing light  
(P21 W), left side.  
Fog lamp (P21 W), right side.  
These 4 bulbs are changed by re-  
moving the light:  
Third brake light  
(4 W 5 W bulbs)  
Using a 10 mm box spanner, un-  
screw the 2 fixing nuts A.  
Release the lamp unit by push-  
ing it outwards.  
Disconnect the connector and  
the rear wash-wipe pipe.  
Turn the bulb holder a quarter of  
a turn and remove it.  
Remove the bulb and change it.  
Note: if necessary, use the wheel-  
brace to remove the nuts.  
When refitting, proceed in the re-  
verse order and take care to position  
the bulb holder, the seal and the light  
correctly.  
Remove the access flap in the  
corresponding boot side trim to  
access the light,  
When refitting, proceed in the reverse  
order and ensure that the lamp unit  
seal and the rear wash-wipe pipe have  
been put back in place correctly.  
Do not tighten the nuts more than is  
necessary at the risk of breaking the  
light.  
Number plate lights (W 5 W)  
Insert a thin screwdriver into one  
of the external holes of the lens.  
Remove the two light fixing nuts  
inside the boot,  
Unclip the harness,  
Remove the light pressing on the  
retaining tabs,  
Remove the seal,  
Push it outwards to unclip it.  
Remove the lens.  
Remove the bulb and change it.  
122