Driving
If R flashes in the instrument panel:
move the gear selector to R, then return it to N.
Operating limits
If you stop the vehicle but keep the engine
running, you must always move the gear
selector to the neutral position N.
-
When on a slope or when hill start assist is
activated, never keep the vehicle stationary
using the accelerator: you could damage the
clutch.
In these situations, an audible signal sounds.
F In that case, move the gear selector to
position N.
Gear shift indicator
System which reduces fuel consumption by
recommending the most appropriate gear.
A continuous audible signal sounds if you
turn the ignition switch to "OFF" while the
vehicle is in 2nd, 3rd, 4th or 5th gear.
If this happens, turn the ignition switch
to "ON", move the gear selector to the
position N, return it to position E, M or R,
then turn the ignition switch to "OFF".
F Wait 15 minutes before moving off again, to
allow the clutch to cool down.
Operation
Depending on the driving situation and the
equipment of your vehicle, the system can
recommend you to change gear.
Gear shift recommendations are for information
only. In fact, the road layout, the traffic density
and safety remain the deciding factors when
choosing the best gear. The driver therefore
remains responsible for deciding whether or not
to follow the indications issued by the system.
This function cannot be deactivated.
Operating faults
If the vehicle is on a slope, use the brake
to stop the vehicle from moving and place
the gear selector to position N, E or R.
With the ignition on, lighting of this
warning lamp indicates a gearbox
fault.
Contact a PEUGEOT dealer or
a qualified workshop.
6
In all cases, you must apply the parking
brake to immobilise the vehicle.
If N flashes in the instrument panel together
Example:
with an audible signal for a long period of time:
-
-
-
You are in third gear.
You press the accelerator pedal.
The system may suggest that you engage
a higher gear.
-
-
make sure that the ignition switch is
correctly set to the "ON" position,
move the gear selector to N, then return it to
E, M or R.
Before doing anything in the engine
compartment, make sure that the gear
selector is in neutral N and the parking
brake is applied.
If 1 flashes in the instrument panel:
-
move the gear selector to E or M, then
return it to N.
79
English 
