Get VISIBILITY -> REAR WIPER CONTROL (407 SW) Guide for Peugeot 407 4 Door First Generation (2004-2011)

Automatic rain sensitive

windscreen wipers

In the event of malfunction, the

windscreen wipers will operate in in-

termittent mode.

Contact a PEUGEOT dealer to have

the system checked.

REAR WIPER CONTROL

(407 SW)

Activation

Move the control to position 0 then re-

turn it to the AUTO position.

An indicator lamp comes on on the in-

strument panel screen, accompanied

by a message on the multifunction

screen.

In the AUTO position, the windscreen

wipers operate automatically and

adapt their speed to the intensity of

the rainfall.

Turn the ring to the ﬁrst notch for inter-

mittent wiping.

The control must be reactivated if

the ignition has been switched off.

To do this, move the control to any

position then return it to the required

position.

Control with Intermittent and

automatic wiping

Manual operation of the wiper stalk by

moving the stalk A up and returning

it to position "0" interrupts the AUTO

position, the deactivation indicator

lamp comes on on the instrument pan-

el screen, accompanied by a message

on the multifunction screen.

Deactivation

Automatic rear wiper

If the windscreen wipers control is ac-

tivated and you engage reverse gear,

the rear wiper operates in intermittent

mode.

Do not cover the rain sensor

located on the windscreen be-

hind the rear view mirror.

When using an automatic car

Control with automatic wiping only

wash to wash your vehicle, switch off

the ignition or check that the wiper

stalk is not in the automatic position.

In winter, it is advisable to wait for the

windscreen to completely clear of ice

before operating the automatic wipers.

Note: if a bicycle carrier is

used, deactivate this function

by going to the "personalisa-

tion - conﬁguration" menu on

the multifunction screen or install a

special bicycle carrier approved by

PEUGEOT.

Manual operation of the wiper stalk in-

terrupts the AUTO position, the deacti-

vation indicator lamp comes on on the

instrument panel screen, accompa-

nied by a message on the multifunc-

tion screen.

Rear wash-wipe

Windscreen and headlamp wash

FRONT COURTESY LAMP

Pull the windscreen wiper stalk towards

you. The windscreen wash then the

windscreen wipers operate for a ﬁxed

period.

The headlamp wash is also activated,

if the headlamps are on.

Screenwash/

headlamp wash low

Turn the ring beyond the ﬁrst notch,

the wash-wipe then the wiper operate

for a set period of time.

When the minimum level of

the reservoir is reached, this

warning light comes on, ac-

companied by an audible

signal and a message on the

multi-function display.

1. Courtesy lamp

2. Map reading lamps

Note: the rear wiper and rear

wash-wipe functions are de-

activated automatically when

the rear screen is opened.

With the key in the ignition on or starting

position, operate the relevant switch.

The front courtesy lamp comes on

when the ignition key is removed, on

unlocking the vehicle or on opening

one of the doors.

It gradually goes off after the ignition

has been switched on or when the ve-

hicle is locked.

Next time you stop, ﬁll the screenwash/

headlamp wash reservoir.

The warning light comes on each time

the stalk is operated, until the reservoir

is ﬁlled.

 Pressing switch 1 turns on the front

courtesy lamp.

The courtesy lamp can be deactivated

by pressing switch 1 with the door open.

The map reading lamps are not affected

by this and may be switched on.

 To re-activate the lamps, press the

switch, with the door open.