Practical information
The start of charging is confirmed when the
charging indicator lamp in the flap flashes green.
If this is not the case, charging has not
started; restart the procedure, ensuring that the
connection has been properly established.
The red indicator lamp in the flap comes on to
indicate that the nozzle is locked.
► Disconnect the control unit's charging cable
from the domestic socket.
It is also possible to monitor the charging
progress using the MYPEUGEOT APP
application.
For more information on Remotely
operable additional functions, refer to the
corresponding section.
9
Accelerated charging (mode 3)
The end of charging is confirmed by the
accelerated charging unit (Wallbox) and when
the green light guides in the flap come on fixed.
Disconnection
► After disconnection, replace the nozzle on to
the charging unit and close the charging flap.
As a safety measure, the engine will not
start if the charging cable is plugged into
the connector on the vehicle. A warning is
displayed on the instrument panel.
Charging the traction
battery (Electric)
Before disconnecting the nozzle from the
charging connector:
Cooling the traction battery
Principle
The cooling fan in the engine compartment
comes on during charging to cool the on-
board charger and the traction battery.
► If the vehicle is locked, unlock it.
For more information, refer to
the General recommendations on
electrified vehicles and the Specific
recommendations on rechargeable hybrid
or electric vehicles.
► If the vehicle is unlocked, lock it and then
unlock it.
Low charging / Driving
If selective unlocking of the doors is
activated, press the unlocking button on
the remote control twice to disconnect the
nozzle.
Driving when the charge level of the
traction battery is too low can lead to the
vehicle breaking down and can lead to
accidents or serious injuries. ALWAYS make
sure the traction battery has a sufficient
charge level.
To recharge, connect the vehicle to a domestic
electricity supply (domestic or accelerated
charging) or to a fast public charger (superfast
charging).
The red indicator lamp in the flap goes out to
confirm that the nozzle is unlocked.
For a full charge, follow the desired charging
procedure without pausing it, until it ends
automatically. Charging can be either immediate
or deferred (except fast public charger, mode 4).
You can stop domestic or accelerated charging
at any time by unlocking the vehicle and
removing the nozzle. For superfast charging,
refer to the fast public charger.
► Within 30 seconds, remove the charging
Low charging / Parking
nozzle.
If the outside temperature is negative, it
is recommended not to park your vehicle
outside for several hours at a low charging
(less than 20%).
Domestic charging (mode 2)
The end of charging is confirmed when the
green CHARGE indicator lamp on the control
unit comes on fixed and the green light guides in
the flap come on fixed.
For more information on the charging displays
on the Instrument panel and the Touch screen,
refer to the corresponding section.
► After disconnection, replace the protective
cover over the nozzle and close the charging
flap.
161
English 