Lighting and visibility
Pressing and holding triggers continuous wiping
at the normal wiping speed.
in the right side menu of the touch screen.
Adjusting the sensitivity
4
Automatic windscreen
wipers
Windscreen wash
► Pull the wiper control stalk towards you and
hold.
In AUTO mode, the front wipers work
automatically and adapt to the intensity of
precipitation depending on the sensitivity of the
sensor selected.
A final wiping cycle is performed when
screenwashing ends.
The lower position corresponds to the lowest
sensitivity of the sensor.
The upper position corresponds to the highest
sensitivity of the sensor.
The higher the sensitivity, the faster the system
reacts and increases the wiping frequency.
A rotation of the ring from a lower position to a
higher position triggers a confirmation wiping.
The rainfall detection function uses a rain/
sunshine sensor located at the top centre of the
windscreen, behind the rear view mirror.
Screenwash fluid is sprayed along the
length of the wiper blade. This improves
visibility and reduces screenwash fluid
consumption.
In certain weather conditions (e.g. fog,
frost, snow, projections on salty roads), the
driver may have to return to manual wiping.
With automatic air conditioning, any action
on the screenwash control results in
temporary closure of the air intake to protect
the passenger compartment from any odour.
After the ignition has been switched off for
more than 1 minute with the wiper control
stalk in the AUTO position, when the ignition
is switched on again:
Switching on/off
To switch on:
► Put the wiper control stalk in the AUTO
– the system works, depending on the volume
of rain detected, as soon as the vehicle
exceeds 6 mph (10 km/h), if the outside
temperature is below +3°C.
position.
To avoid damaging the wiper blades,
do not operate the screenwash if the
screenwash reservoir is empty.
Only operate the screenwash if there is no
risk of the fluid freezing on the windscreen
and hindering visibility. During the winter
period, use "very cold climate" rated products.
Never top up with water.
► Turn the ring to adjust the sensitivity of the
sensor.
– the system works immediately, depending
on the volume of rain detected, if the outside
temperature is above +3°C.
A wiping cycle, accompanied by the display of
a message, confirms that the request has been
taken into account.
► To switch off, put the wiper control stalk in
Do not cover the rain/sunshine sensor.
When using an automatic car wash, switch
off the automatic wipers and the ignition.
In winter, wait until the windscreen is
completely clear of ice before activating the
automatic wipers.
another position or in the 0 position.
An additional jet is fitted above the number plate
to clean the reversing camera (depending on
version).
With reverse gear engaged, the
washing of the reversing camera is
triggered by clicking on this button
79
English 