Advanced Driving Assistance Systems (ADAS)
during few seconds after turn lights have been
switched off.
Depending on version, only lane departure
warning system is active, when a system fault is
present, a spare wheel used, Electronic Stability
Control is not activated or e.g. a trailer is
attached.
Due to legal requirements, the system can only
be deactivated in the vehicle personalization
until the next time the ignition is reactivated.
The system is automatically activated by default
every time the engine is started.
The system will inform the driver with a message
and a chime if there is an ongoing correction
for more than ten seconds. If the driver is still
unable to keep the vehicle in the lane, the
correction interrupts after a short time.
When hands-off driving is detected during a
correction a warning message appears in the
Driver Information Centre, accompanied by a
warning chime. Every further hands-off detection
prolongs the warning chime duration.
Unavailability After Battery Disconnection
NOTE:
Depending on version, the system is
automatically reactivated at the next engine
start.
Lane Keeping Assist can be temporarily
unavailable or inactive when the power supply
of the vehicle is reconnected again.
Deactivation
Activation
A lane departure warning in the Driver
Information Centre alerts when the system
cannot hold the vehicle within the lane and
immediate driver´s action is required.
To deactivate the system, either press
the LED in the button is illuminated or deactivate
the system in the Info Display via the vehicle
until
settings
.
LKA shall be deactivated by the driver when the
vehicle is being towed.
NOTE:
The system might be inactive if it detects lanes
that are too narrow, too wide or too curved.
Fault
For correct operation of the system, the following
preconditions must be fulfilled:
In the event of a fault,
and
appear in
the Driver Information Centre, accompanied by a
display message and a warning chime. Seek the
assistance of a workshop.
-
vehicle speed must be between 65 km/h and
180 km/h
If a sensor is covered,
illuminates in the
-
-
the turn lights are not activated
Driver Information Centre and a message is
displayed indicating that the sensors have to be
cleaned.
If the system is activated, the LED in the button
is not illuminated. To activate the system
the electronic stability control is activated and
not in operation
-
-
-
no plug is connected to the power outlet of
the trailer hitch
If the audible warning system does not work
when the system is deactivated, press
The system may also be activated in the Info
properly or is not available,
cluster and a message is displayed. Consult a
workshop.
illuminates on the
no dynamic driving, i.e. pressure on the
brake or accelerator pedal
Display via the vehicle settings
.
Depending on version, the system is always ON,
even if it was deactivated during the last driving
cycle.
The system can be activated or deactivated in
the vehicle personalization through the vehicle
lane boundaries can be clearly detected by
the system
System limitations
The system performance may be affected by
heavy curves and construction areas.
-
-
-
no temporary spare wheel is used
the vehicle is not driven in a tight corner
no system fault is present that prevents
corrections
settings
.
142
English 
