Advanced Driving Assistance Systems (ADAS)
materials, may not be detected by the
system.
Do not drive or park the vehicle using only the
surround vision system.
Always check the surrounding of the vehicle
before and during driving.
Displayed images may be further or closer
than they appear. The area displayed is
limited and objects that are close to either
edge of the bumper or under the bumper are
not displayed on the screen.
Warning
Under certain circumstances, various
reflective surfaces on objects or clothing as
well as external noise sources may cause the
system to fail to detect obstacles.
Special attention must be paid to low
obstacles, which can damage the lower part
of the bumper.
Parking assist systems do not detect objects
outside the detection range, e.g. below the
bumper or underneath the vehicle.
During a reverse parking manoeuvre, the
system does not consider a mounted coupling
ball bar. The driver must consider this
additional length.
Depending on the load of the vehicle, the
inclination of the vehicle may be changed
including the view of the camera.
NOTE:
Caution
In the case of a severe failure of the
vehicle with the need to stop the vehicle, the
system is deactivated.
In the case of a gearbox failure, the parking
assist system is not active, when reverse
gear is engaged.
In the case of a loudspeaker failure, the
audible signals may not be given.
Performance of the system can be reduced
when sensors are covered, e.g. by ice or
snow.
It is possible that the sensor detects a non-
existing object caused by echo disturbance
from external acoustic noise or mechanical
misalignments (sporadic false warnings may
occur).
Make sure that the front number plate is properly
mounted (not bent and no gaps to the bumper
on the left or right side) and the sensors are
firmly in place. The performance of the parking
assist may be reduced if the licence plate is bent
or a licence plate support is used.
The system may use:
-
-
rear camera, installed in the tailgate
ultrasonic parking assist sensors in the rear
bumper
Visualisation on the Info Display
If a sensor is covered, a message is
displayed indicating that the sensors must be
cleaned.
Performance of the parking assist system
may be limited or the functionality may not be
Low curbs and surface irregularities, e.g. on
construction zones, are not detected by the
system. The driver accepts responsibility.
Surround Vision
This system allows views of the vehicle's
surroundings to be displayed as a nearly 180°
picture in the Info display, like a bird's eye view.
The screen is divided into four areas, from left to
right:
available at all if
illuminates or if the image
shown on the Info Display is frozen or if the
screen is black.
Performance of the parking assist system can
be reduced due to heavy loading.
Special conditions apply if there are taller
vehicles in the vicinity (e.g. off-road vehicles,
mini vans, vans). Object identification and
correct distance indication in the upper part
of these vehicles cannot be guaranteed.
Objects with a very small reflection cross-
section, e.g. objects of narrow size or soft
-
-
-
selectable views: standard and 180° view
view visualisation
Warning
top view
The surround vision system does not
replace driver vision. It will not display
children, pedestrians, cyclists, crossing traffic,
animals, or any other objects outside of the
camera view area, e. g. below the bumper, or
underneath the vehicle.
-
settings
audible signal
, muting v and unmuting the
The parking sensors complete the information on
the view from above the vehicle.
146
English 
