Get Advanced Driving Assistance Systems -> Speed control assistance system Guide for Peugeot Expert Van Third Generation (2016-2025)

Advanced Driving Assistance Systems (ADAS)

The driver can accelerate the vehicle up to the

preset speed. Deviations from the limited speed

may occur when driving downhill.

Setting speed by the driver

Introduction To

Assistance Systems

Switching on the system

General information

Warning

Driver assistance systems are developed

to support the driver and not to replace the

driver's attention.

The driver accepts full responsibility when

driving the vehicle.

When using driver assistance systems,

always take care regarding the current traffic

situation.

The preset speed can be changed by moving

the thumb wheel to

to increase or

NOTE:

to decrease the speed. Move thumb wheel

repeatedly to change speed in small steps, move

and hold to change speed in large steps.

To comply with the European general safety

regulations, some driver assistance systems can

only be deactivated on the Info Display until the

next time the ignition is reactivated. The system

is automatically activated by default every time

the engine is started.

Press

Depending on version, either the speed limiter

screen or only displayed.

is grey indicating that the system is still not

Adopting speed by the speed limit

recognition

A detected speed limit can be used as new set

speed for the speed limiter.

Depending on version, the traffic sign assistant

has to be activated to detect speed limit signs.

active.

BEV

Activation of the functionality

Due to the vehicle’s quiet operation when

driving, the driver must pay particular attention.

Press OK or

to activate the speed limiter.

When passing the speed limit sign

is illuminated in green or white.

With activated speed limiter, OK? is

automatically displayed.

Press OK on the steering wheel to store the

suggested speed.

Speed control assistance

system

The suggested speed is shown as new speed

setting.

Speed limiter

The speed limiter prevents the vehicle exceeding

a preset maximum speed.

The maximum speed can be set at speeds

above 30 km/h.

After passing the speed limit sign

With activated speed limiter, press OK on the

steering wheel.

OK? is displayed.

129

Advanced Driving Assistance Systems (ADAS)

Press OK to store the suggested speed.

The suggested speed is shown as new speed

setting.

Fault

Switching on the system

The speed limit recognition may not operate

correctly if traffic signs do not comply with the

Vienna Convention on Road Signs and Signals.

In the event of a speed limiter fault, the speed is

cleared resulting in flashing of the dashes.

Have the system checked by a workshop.

Exceeding the speed limit

In the event of an emergency, it is possible

to exceed the speed limit by depressing the

accelerator pedal firmly to the final point. In this

case, the preset speed value flashes.

Release the accelerator pedal and the speed

limiter function is reactivated once a speed lower

than the limit speed is obtained.

Cruise control

The cruise control can store and maintain

speeds above 40 km/h.

When exceeding the preset speed is not caused

by depressing the accelerator pedal, e.g., when

driving down a steep slope, an audible signal is

given.

For vehicles with manual transmission, any gear

has to be selected. For vehicles with automatic

transmission, position D or the second or a

higher gear in position M must be selected.

Deviations from the stored speeds may occur

when driving uphill or downhill.

Press

Warning

Depending on version, either the cruise control

On a steep descent or in the event of

sharp acceleration, the speed limiter will not

be able to prevent the vehicle from exceeding

the preset speed. If necessary, depress the

brake pedal to control the vehicle’s speed.

The system maintains the vehicle speed at the

preset speed by the driver, without any action on

the accelerator pedal.

The preset speed can be exceeded temporarily

by pressing the accelerator pedal firmly.

The status and preset speed is displayed in the

Driver Information Centre.

screen or only

is displayed.

is grey indicating that the system is still not

active.

Activation of the functionality

Deactivation of the functionality

If all operating conditions are met, OK? is

displayed.

Press OK to store the current vehicle speed as

Do not use the cruise control if it is not advisable

to maintain a constant speed.

Press

, speed limiter is in pause mode.

illuminated in grey. The vehicle is driven without

speed limiter.

Speed limiter is deactivated, but not switched off.

Last stored speed remains in memory for later

speed resume.

speed setting and activate the cruise control.

changes from grey to green or white indicating

that system is active. The accelerator pedal can

be released.

Alternatively, move the thumb wheel to

increase or to decrease the speed and

Resume limit speed

store this speed as speed setting. Cruise control

is immediately activated if the thumbwheel is

Press

obtained.

or OK, the stored speed limit will be

moved upwards or downwards.

from grey to green or white.

changes

Switching off the system

Press , the speed limiter mode is deselected

and the speed limiter screen is hidden from the

Driver Information Centre or

extinguishes.

130

Advanced Driving Assistance Systems (ADAS)

OK? is displayed Press OK to store the

suggested speed.

The suggested speed is shown as new speed

setting.

Setting speed by the driver

System limitations

Never use the system in the following situations:

In an urban area with the risk of pedestrians

crossing the road.

Exceeding the set speed

In heavy traffic.

It is always possible to drive faster than the

set speed by depressing the accelerator pedal.

When the accelerator pedal is released, the

vehicle returns to the stored speed.

While the set speed is exceeded, the set speed

setting flashes.

On winding or steep roads.

On slippery or flooded roads.

In poor weather conditions.

In the event of restricted visibility for the

driver.

Deactivation of the functionality

Driving on a speed circuit.

Driving on a rolling road.

Press

. Cruise control is in pause mode.

is illuminated grey. The vehicle is driven without

cruise control.

When using snow chains, nonslip covers or

studded tires.

If the system is active, the preset speed can be

Cruise control is deactivated, but not switched

off. Last stored speed remains in memory for

later speed resume.

The cruise control may be deactivated

automatically in the following cases:

changed by moving the thumb wheel to

When driving down a steep hill, the system

cannot prevent the vehicle from exceeding the

set speed. Brake if necessary.

increase or to decrease the speed. Move

thumb wheel repeatedly to change speed in

small steps, move and hold to change speed in

large steps.

When driving up a steep hill or when towing, the

set speed may not be reached or maintained.

brake pedal depressed

Adopting speed by the speed limit

recognition

Fault

traction control system or electronic stability

control is operating

The speed limit recognition may not operate

correctly if traffic signs do not comply with the

Vienna Convention on Road Signs and Signals.

In the event of a cruise control fault, the speed is

cleared resulting in flashing of the dashes.

Have the system checked by a workshop.

A detected speed limit can be used as new set

speed for the cruise control.

Depending on version, the traffic sign assistant

has to be activated to detect speed limit sign.

reverse gear engaged, N selected or no gear

engaged

clutch pedal depressed for more than five

seconds

When passing the speed limit sign

electric parking brake engaged

With activated cruise control, OK? is

automatically displayed.

Adaptive cruise control

Resume stored speed

Press OK on the steering wheel to store the

suggested speed.

(ACC)

Press

or OK, the stored speed will be set.

The adaptive cruise control is an enhancement

of the cruise control with the additional feature

of maintaining a certain following distance to the

vehicle ahead.

The suggested speed is shown as new speed

setting.

Switching off the system

After passing the speed limit sign

Press

, the cruise control mode is deselected

and the cruise control screen is hidden from the

With activated cruise control, press OK on the

steering wheel.

Driver Information Centre or

131

Advanced Driving Assistance Systems (ADAS)

brake pedal depressed if vehicle stationary

Warning

The brake lamps come on if the vehicle is

slowed down.

If the brake lights fail, the system does not

operate.

Activation of the functionality

If all operating conditions are met, OK? is

displayed.

Press OK to store the current vehicle speed and

activate the cruise control.

On the adaptive cruise control screen, the set

speed and a road element are displayed in

green. The accelerator pedal can be released.

Switching on the system

It uses a radar unit located in the front bumper to

detect the vehicles ahead.

If no vehicle is detected in the driving path,

the adaptive cruise control will behave like a

conventional cruise control.

Alternatively, move the thumb wheel to

increase or to decrease the speed and store

this speed. The cruise control is immediately

activated if the thumbwheel is moved upwards

or downwards. On the adaptive cruise control

screen, the set speed and the road element are

displayed in green.

The adaptive cruise control automatically

decelerates the vehicle when approaching a

slower moving vehicle. It then adjusts the vehicle

speed to follow the vehicle ahead at the selected

following distance. The vehicle speed increases

or decreases to follow the vehicle ahead, but will

not exceed the set speed. It may apply limited

braking with activated brake lights.

Setting speed by the driver

If the vehicle ahead accelerates or changes

lane, the adaptive cruise control progressively

accelerates the vehicle to return to the stored

set speed. If the driver operates the turn lights

to overtake a slower vehicle, the adaptive

cruise control allows the vehicle to temporarily

approach the vehicle ahead to help passing it.

However, the set speed will never be exceeded.

If the vehicle ahead is moving too slowly

and the selected following distance cannot be

maintained anymore, a warning chime is given

and a message is displayed. The message

prompts the driver to take back control of the

vehicle. On vehicles with manual transmission,

the system can brake the vehicle until 30 km/h.

On vehicles with automatic transmission, the

system can brake the vehicle until a full stop.

Depending on the version, the system can

automatically accelerate the vehicle after a full

stop.

Press

successively until the adaptive cruise

control mode is selected.

The adaptive cruise control screen is displayed.

The system is still not activated.

Activation conditions

The system can be activated if the following

conditions are met:

vehicle speed between 30 km/h and 180

km/h for vehicles with manual transmission,

between 0 km/h and 180 km/h for vehicles

with automatic transmission

The set speed can be changed by moving

the thumb wheel to

to increase or

to decrease the speed. Move thumb wheel

repeatedly to change speed in small steps, move

and hold to change speed in large steps.

driver's door closed

driver's seat belt fastened

D selected or second or higher gear engaged

parking brake released

132

Advanced Driving Assistance Systems -> Speed control assistance system for Your Peugeot Expert Van Third Generation (2016-2025)

Related Topics

Advanced Driving Assistance Systems

Popular Owner Manuals

Latest Owner Manuals