2016-2026 Peugeot Traveller Van Safety -> Seat belts User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Safety -> Seat belts for Your Peugeot Traveller Van First Generation (2016-2026)

Safety  
Seat belts  
Front seat belts  
Fastening  
Height adjustment  
F
F
Pull the strap, then insert the tongue in the  
buckle.  
Check that the seat belt is fastened  
correctly by pulling the strap.  
F
F
To lower the attachment point, while  
moving control A downwards, slide the  
assembly down to the desired position.  
To raise the attachment point, slide the  
assembly up to the desired position.  
The front seat belts are fitted with a  
pretensioning and force limiting system.  
This system improves safety in the front  
seats in the event of a front or side impact.  
Depending on the severity of the impact, the  
pretensioning system instantly tightens the seat  
belts against the body of the occupants.  
The pretensioning seat belts are active when  
the ignition is on.  
Unfastening  
F
F
Press the red button on the buckle.  
guide the seat belt as it reels in.  
The upper part of the diagonal strap  
should lie across the shoulder.  
The force limiter reduces the pressure of the  
seat belt on the chest of the occupant, so  
improving their protection.  
164  
Safety  
2 seat front bench seat  
Rear seat belts  
For rows 2 and 3, fit each seat belt to its  
correct buckle.  
Do not interchange the belts or buckles  
for the outer seats with the belt or  
buckle for the centre seat.  
When folding the outer seats or placing  
a backrest in the table position, avoid  
trapping the belt for the centre seat.  
After folding a rear seat or bench seat,  
ensure that the seat belt has reeled  
in correctly and the buckle is ready to  
receive the belt tongue.  
When handling the outer seats  
(removing or refitting) or for access to  
row 3, avoid trapping the centre belt.  
5
If your vehicle is fitted with a front bench seat,  
ensure that each belt is used with its correct  
buckle.  
Do not interchange the driver's seat belt or  
buckle with the centre seat belt or buckle.  
If your vehicle is fitted with a 3-seat bench seat  
(one piece or 1/3 - 2/3 split), these are fitted  
with three-point seat belts and inertia reels on  
the outer seats.  
And the centre seat has its own guide and reel,  
built into the seat backrest.  
The seat belt reels for the outer seats in row 2  
have force limiters.  
The seats in row 3 have three-point seat belts  
with inertia reels.  
165  
Safety  
Seat belt warning lamps  
If your vehicle has individual front seats:  
1. Driver's seat belt not fastened / unfastened  
warning lamp in the instrument panel.  
2. Front passenger seat belt not fastened /  
unfastened warning lamp.  
If your vehicle has a 2-seat bench front seat:  
A. outer left (driver) seat belt not fastened /  
unfastened warning lamp.  
B. Centre and/or outer seat belt not fastened  
warning lamp.  
If your vehicle is fitted with individual seats,  
they have three-point seat belts with their  
guides and belt reels built into the backrests.  
on switching on the ignition, a warning lamp  
comes on in the instrument panel if the  
corresponding seat belt is not fastened or is  
unfastened.  
When the ignition is switched on, the warning  
lamp A comes on if the driver's seat belt is not  
fastened or unfastened.  
The warning lamp B comes on if the centre  
and/or an outer seat belt is unfastened.  
From about 12 mph (20 km/h) and for  
two minutes, the warning lamps(s)  
flash accompanied by an audible  
signal. Beyond these two minutes,  
the warning lamps remain on if the  
driver or front passenger do not  
fasten their seat belt(s).  
166  
Safety  
Recommendations for children  
Advice  
use a suitable child seat if the passenger is  
less than 12 years old or shorter than one  
and a half metres.  
Never use the same seat belt to secure more  
than one person.  
Never allow a child to travel on your lap.  
For more information on Child seats, refer  
to the corresponding section.  
The driver must ensure that passengers use  
the seat belts correctly and that they are all  
fastened before setting off.  
Wherever you are seated in the vehicle,  
always fasten your seat belt, even for short  
journeys.  
In order to be effective, a seat belt must:  
-
be tightened as close to the body as  
possible,  
-
be pulled in front of you with a smooth  
movement, checking that it does not  
twist,  
Do not interchange the seat belt buckles as  
they will not fulfill their role fully.  
-
-
-
be used to restrain only one person,  
not bear any trace of cuts or fraying,  
not be converted or modified to avoid  
affecting its performance.  
The seat belts are fitted with an inertia reel  
permitting automatic adjustment of the  
length of the strap to your size. The seat belt  
is stowed automatically when not in use.  
Before and after use, ensure that the seat  
belt is reeled in correctly.  
The lower part of the strap must be  
positioned as low as possible on the pelvis.  
The upper part must be positioned in the  
hollow of the shoulder.  
The inertia reels are fitted with an automatic  
locking device which comes into operation in  
the event of a collision, emergency braking  
or if the vehicle rolls over. You can release  
the device by pulling the strap firmly and  
then releasing it so that it reels in slightly.  
In accordance with current safety  
regulations, for all repairs on your vehicle's  
seat belts, go to a qualified workshop with  
the skills and equipment needed, which a  
PeugeoT dealer is able to provide.  
Have your seat belts checked regularly by a  
PeugeoT dealer or a qualified workshop,  
particularly if the straps show signs of  
damage.  
Clean the seat belt straps with soapy  
water or a textile cleaning product, sold by  
PeugeoT dealers.  
After folding or moving a seat or rear bench  
seat, ensure that the seat belt is positioned  
and reeled in correctly.  
5
In the event of an impact  
Depending on the nature and  
seriousness of the impact, the  
pretensioning device may be deployed  
before and independently of the airbags.  
Deployment of the pretensioners is  
accompanied by a slight discharge of  
harmless smoke and a noise, due to the  
activation of the pyrotechnic cartridge  
incorporated in the system.  
In all cases, the airbag warning lamp comes  
on.  
Following an impact, have the seat belts  
system checked, and if necessary replaced,  
by a PeugeoT dealer or a qualified  
workshop.  
167  

Related Topics

Popular Owner Manuals