
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Tyres and Wheels
254
located in the main tread channels and display the
minimum tread depth of 1.6 mm.
e Check the tyre tread regularly, particularly before
and after long journeys.
Measuring the tyre tread depth
e Insert a commercially available tread depth
gauge or calliper in the tyre tread and measure
the tyre tread depth.
Information
Uneven tyre wear indicates a defect on the vehicle:
e Visit a qualified specialist workshop. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
Storing wheels
Tyres must not be more than 6 years old. Chemical
additives, which make the rubber in the tyre elastic,
lose their effect over the course of time and the
rubber becomes brittle. The age of a tyre can be
seen from the DOT code on the tyre sidewall. If the
last four digits are 3016, for example, the tyre was
manufactured in the 30th week of 2016.
e Always store wheels in cool, dry and dark condi-
tions. Tyres without rims should be stored in a
standing position.
e Do not store summer tyres or park vehicles fitted
with summer tyres at ambient temperatures be-
low –15 °C.
e Avoid contact with petrol, oil and grease.
Balancing wheels
As a precaution, have wheels balanced in spring
(summer tyres) and before winter (M+S tyres).
e Visit a qualified specialist workshop. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
Changing a wheel
WARNING
Working under the
vehicle
The vehicle can slip off the jack.
e Make sure that no one is in the vehicle when
jacking up and changing a wheel.
e Raise the vehicle only at the prescribed jacking
points on the vehicle underbody.
e Never jack up the vehicle when it is parked on a
surface that slopes up, down or to the side.
e Only use the jack to raise the vehicle for chang-
ing wheels.
e Always place the vehicle on solid supports when
working under the vehicle.
> Please refer to chapter "Jack and Lifting Plat-
form" on page 138.
Information
The tools needed for changing wheels (jack, wheel
bolt wrench, mounting aids, etc.) are not included in
the standard scope of supply for the vehicle.
e For information on the tool required: Contact
your Porsche partner.
Information
The tyre and wheel sizes are different on each of the
two axles. When wheels are removed, mark the di-
rection of rotation and position of each wheel and fit
the wheels in accordance with this marking.
e Only use wheels/tyres with approved dimensions
for each axle.
Vehicle registration documents or Please refer to
chapter "Technical Data" on page 308.
Caring for wheel attachment faces
Fig. 213: Wheel attachment faces