2019-2024 Porsche Taycan 2 Door Tyres and Wheels -> Tyre Pressure Monitoring (TPM) User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Tyres and Wheels -> Tyre Pressure Monitoring (TPM) for Your Porsche Taycan 2 Door First Generation (2019-2024)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Tyres and Wheels
249
Tyres and Wheels
In addition to correct tyre inflation pressure and
correct wheel alignment, the service life of the tyres
also depends on your driving style. Abrupt accelera-
tion, high cornering speeds and heavy braking in-
crease tyre wear. Tyre wear is also greater at higher
outside temperatures and on rough road surfaces.
Complying with load and speed
requirements
e Drive at an appropriate speed.
e Do not overload the vehicle, and check the roof
load.
> Please refer to chapter "Technical Data" on
page 308.
Checking tyre pressure
NOTICE
Insufficient tyre pressure can cause tyres to over-
heat and thus be damaged – even invisibly.
e Hidden tyre damage will not be eliminated by
correcting the tyre pressure.
e Never let air out of warm tyres. When tyres are
warm, the tyre inflation pressure is increased.
This could cause the tyre pressure to fall below
the prescribed value.
Fig. 210: Tyre-pressure plate fixing point
The tyre inflation pressure must match the pre-
scribed value. These values are for cold tyres (20 °
C).
e Observe tyre-pressure plate.
e Check the tyre pressure at least every 2 weeks
when the tyres are cold.
Tyre Pressure Monitoring (TPM)
Tyre Pressure Monitoring offers the following
functions:
– Permanent monitoring of tyre pressure and
temperature.
– Display of actual tyre pressure (actual pressure)
while driving.
– Tyre pressure warnings in two stages (yellow and
red warning).
– Vehicle is stationary: Display of the pressure de-
viation from the required pressure.
The tyre pressure warning light
and a corre-
sponding message on the instrument cluster warn
against loss of pressure in two stages (yellow and
red tyre pressure warning, depending on the extent
of the pressure loss).
The tyre pressure warning light goes out only when
the tyre pressure has been corrected.
The yellow tyre pressure warning is displayed for
around 10 seconds after the car comes to a stand-
still and is switched off or when the vehicle is turned
on again. The yellow tyre pressure warning can be
acknowledged when the vehicle is turned on. The red
tyre pressure warning also appears during driving
and can be acknowledged.
e If the tyre pressure warning light lights up and a
tyre pressure warning is displayed despite the
correct tyre pressure: Visit a qualified specialist
workshop. Porsche recommends a Porsche part-
ner as they have trained workshop personnel and
the necessary parts and tools.
Information
Tyre Pressure Monitoring gives a warning about a
pressure drop caused by natural diffusion as well as
about a gradual loss of pressure caused by foreign
objects. Tyre Pressure Monitoring cannot warn you
about tyre damage that occurs suddenly (e.g. a flat
tyre due to unexpected external effects).
WARNING
Defective tyres
Driving with defective tyres can result in serious
accidents.
e When a red tyre pressure warning appears on the
instrument cluster: stop immediately in a suit-
able place and check the tyres for damage. If
necessary, correct the damage using tyre sealant
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Tyres and Wheels
250
or fit the spare wheel.
e Do not continue driving with defective tyres.
Have defective tyres replaced immediately. Visit
a qualified specialist workshop. Porsche recom-
mends a Porsche partner as they have trained
workshop personnel and the necessary parts and
tools.
e Do not drive with tyres in which the tyre pressure
drops again very quickly. In case of doubt, have
tyres checked by a qualified specialist workshop.
Porsche recommends a Porsche partner as they
have trained workshop personnel and the neces-
sary parts and tools.
Faults in the Tyre Pressure Monitoring (TPM)
system
TPM will not function correctly in the following sit-
uations, for example:
– If the Tyre Pressure Monitoring is faulty
– If wheel transmitters for Tyre Pressure Monitor-
ing are missing
– During the learning phase after the tyre settings
have been updated
– After a wheel change without updating the tyre
settings
– If tyre temperatures are too high
Checking the tyre pressure in the instrument
cluster
The individual tyre pressures are only displayed
above a speed of approx. 25 km/h (16 mph) or if the
tyre has been inflated by at least 0.1 bar (1.5 psi).
When the vehicle is turned on after the vehicle has
been stationary for more than approx. 10 minutes,
lines (-.-) will appear instead of the tyre pressures.
e Tyre info e Current press.
> Please refer to chapter "Operating the instru-
ment cluster" on page 129.
The display of the actual pressure is only for infor-
mation. The tyre pressures change depending on the
temperature.
e Under no circumstances should the tyre pres-
sures be changed based on this display.
Checking the pressure deviation in the in-
strument cluster
Fig. 211: Example of pressure difference
bb Vehicle is stationary.
e Tyre info e Pressure deviation
> Please refer to chapter "Operating the instru-
ment cluster" on page 129.
The difference to the required pressure is displayed
on the relevant wheel. Example:
If –0.1 bar (–1.5 psi) is displayed for the rear right
wheel, 0.1 bar (1.5 psi) must be added to this tyre.
The displayed pressures take into account the tyre
temperature.
e Always use the pressure deviation from the dis-
play or from the corresponding tyre pressure
warning to correct the tyre pressure.
Setting tyres
Settings for tyre type, tyre size and load can be ad-
justed via the central display:
> Please refer to chapter "Configuring Tyre Pres-
sure Monitoring (TPM) on the central display" on
page 250.
Configuring Tyre Pressure Moni-
toring (TPM) on the central
display
WARNING
Incorrect settings
Low or high tyre pressure irreparably damages the
tyre and the wheel, lengthens the braking distance
and greatly increases the risk of an accident.
Despite the Tyre Pressure Monitoring system, it is
still the driver’s responsibility to ensure that the
tyres are inflated with the correct tyre pressure and
the vehicle settings are correct. Incomplete or in-
correct settings may affect the accuracy of warnings
and messages.
e Adapt tyre pressure to suit your specific tyres
and the payload.
e Make sure that the settings in the TPM menu
correspond to the tyres fitted on the vehicle and
its payload (especially after a wheel change or
changes in vehicle loading).
e Then select the type and size of fitted tyre again
in the TPM menu, even if the settings for the
newly fitted set of wheels are the same as for the
old wheels.
Accessing filling information
bb Vehicle is stationary.
e
e Setting e Vehicle eTyre pressure
monitoring
Load, tyre type and tyre size settings are displayed:

Related Topics

Popular Owner Manuals