2019-2024 Porsche Taycan 2 Door Tyres and Wheels -> Changing tyres and wheels User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Tyres and Wheels -> Changing tyres and wheels for Your Porsche Taycan 2 Door First Generation (2019-2024)

A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Tyres and Wheels
252
Reading off inscription on tyres
Fig. 212: Inscription on tyres
A Nominal width in mm
B Cross-section ratio in %
C Belt type code letter
D Rim diameter in inches
E Load rating code number
F Speed code letter
The speed code letter F indicates the maximum
permitted speed for the tyre.
H
up to 210 km/h (130 mph)
V
up to 240 km/h (150 mph)
W
up to 270 km/h (168 mph)
Y
up to 300 km/h (186 mph)
(Y) up to 300 km/h (186 mph) as for Y
tyres. Speeds of more than 300 km/h
(186 mph) are also possible at a max-
imum tyre load capacity of 85 % (con-
firmation from tyre manufacturer
required for speeds of more than
300 km/h (186 mph)).
Detecting tyre damage
WARNING
Hidden tyre damage and
rim flange damage
Hidden tyre damage can cause the tyre to burst. You
may lose control of the vehicle.
e Check tyres, including the sidewalls, regularly for
foreign bodies, nicks, cuts, cracks and bulges.
e Cross kerb edges slowly and at right angles if
possible. Avoid heavy or sharp-angled impact
against steep and sharp kerbs or sharp-edged
objects (e.g. stones).
e If in doubt, have the wheel – particularly the in-
ner side – checked by an expert. Visit a qualified
specialist workshop. Porsche recommends a
Porsche partner as they have trained workshop
personnel and the necessary parts and tools.
e Tyres must never be repaired under any circum-
stances. Sealing the tyre with the tyre sealant is
only an emergency solution to enable you to
drive to the nearest workshop.
In the case of the following tyre damage, the tyre
must be replaced for safety reasons:
– Tyre damage where the possibility of a ply frac-
ture cannot be ruled out.
– If the tyre has been thermally and mechanically
overloaded following a loss of pressure or other
previous damage.
Changing tyres and wheels
e Switch off the ignition when changing a wheel.
WARNING
Lack of grip
In the initial period, new tyres do not yet have their
full road-holding ability or grip.
e You should therefore drive at moderate speeds
during the first 200 km (125 miles) to extend
the service life of the tyres and achieve full per-
formance capability.
e Only fit tyres of the same make and type and
with the same specification number (e.g. "N...").
e Before fitting new tyres, inquire about their cur-
rent approval status: Contact your Porsche
partner.
e Use only tyre makes tested and approved by
Porsche.
e The deviation in tread depth on an axle must not
be more than 30 %.
e Only use second-hand tyres if you know their
history.
e Always replace both tyres on an axle so that dif-
ferent profile depths will not unnecessarily influ-
ence vehicle handling.
e Tyres should only be fitted by professionals. Visit
a qualified specialist workshop. Porsche recom-
mends a Porsche partner as they have trained
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
Tyres and Wheels
253
workshop personnel and the necessary parts and
tools.
e Adapt your driving style to the changed vehicle
handling.
e Only use tyres with tyre pressure sensors for Tyre
Pressure Monitoring (TPM).
e Make sure that the wheels are compatible with
the TPM system in the vehicle. For information
on suitable wheels and on the TPM system in the
vehicle: Contact your Porsche partner.
e When changing a tyre, check the battery charge
condition of the tyre pressure sensors: Visit a
qualified specialist workshop. Porsche recom-
mends a Porsche partner as they have trained
workshop personnel and the necessary parts and
tools.
> Please refer to chapter "Technical Data" on
page 308.
Information
If new tyres are fitted to only one axle, the different
tread depths on the two axles can cause a marked
change from the previous driving behaviour to which
you have become accustomed. This is particularly
true when new tyres are fitted to the rear axle. The
effect is reduced continuously, however, as tyre
mileage increases.
Checking and replacing valves and
valve caps
e Use only genuine Porsche valves for the Tyre
Pressure Monitoring (TPM) system.
e Check the valves whenever the tyres are
changed and replace them if necessary. Porsche
recommends a Porsche partner as they have
trained workshop personnel and the necessary
parts and tools.
If valve caps are missing, the valve is unprotected
from dust and dirt, resulting in leaks.
e Always screw on valve caps tightly to protect
valve inserts from dirt. Dirty valve inserts can
cause creeping air loss.
e Replace missing valve caps immediately.
e Use only plastic valve caps.
Using winter tyres
WARNING
Exceeding the maximum
permitted speed
Exceeding the maximum permitted speed can cause
tyres to burst.
e Observe the maximum permitted speed for the
tyre.
e Only fit winter tyres rated for a lower permitted
top speed than the specified maximum vehicle
speed if they bear the M+S designation or the
snowflake symbol on the tyre sidewall. Observe
country-specific laws.
e Affix a sticker showing the maximum permitted
speed in the driver’s field of vision. Observe
country-specific laws.
e Set the maximum permitted speed as the speed
limit.
e Install winter tyres in a timely manner before the
cold season begins.
e Use only tyre makes tested and approved by
Porsche.
e Before fitting new tyres, inquire about their cur-
rent approval status: Contact your Porsche
partner.
Information
At low temperatures, juddering noises caused by the
tyres can occur during manoeuvering or accelerating
out of curves on both dry and wet road surfaces.
The driving performance and comfort of summer
tyres is reduced at low temperatures below 7 °C.
Porsche therefore recommends that you fit winter
tyres on the vehicle when temperatures are below
7 °C.
Extremely low temperatures below –15 °C can
cause permanent damage to summer tyres.
Winter tyres are no longer suitable if their tread
depth is less than 4 mm.
Using snow chains
Snow chains can be fitted to the rear axle only, with
the tyre/wheel combinations listed under "Technical
Data" and marked for snow chain use.
> Please refer to chapter "Technical Data" on
page 308.
e Use only the snow chains approved by Porsche
to guarantee sufficient clearance between the
wheel well and the chain.
e Remove ice and snow deposits in the wheel well
before installing the chains.
e Vehicles with rear axle steering: Deactivate rear
axle steering.
–
e Setting e Vehicle settings e Addi-
tional chassis settings
e Observe the different national regulations re-
garding maximum speeds.
Checking tyre tread
Most tyres have integrated wear indicators in the
centre of the tread. These wear indicators are

Related Topics

Popular Owner Manuals