2005-2013 Renault Clio 4 Door Getting to know your vehicle -> Headrests - Seats User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Getting to know your vehicle -> Headrests - Seats for Your Renault Clio 4 Door Third Generation (2005-2013)

FRONT HEADRESTS  
3
1
2
To raise it  
To remove it  
Lift the headrest to its highest position.  
Press button 2 and lift the headrest to  
release it.  
To replace it  
(depending on vehicle)  
Pull the headrest upwards to the de-  
sired height.  
If the rod setting has been altered, pull  
rods 3 out fully (check that they are  
properly aligned and clean). If you are  
having difficulty, check that the notches  
are facing the front.  
Note: when the headrest is removed,  
take care not to change the positions  
of rods 3.  
To lower it  
(depending on vehicle)  
Press button 1 and guide the headrest  
down to the desired height.  
Insert the headrest rods into the holes  
(tilt the seatback backwards if neces-  
sary).  
Push the headrest downwards until it  
clicks, check that it is properly locked.  
Press button 1 and push the headrest  
down as far as it will go.  
The headrest is a safety  
component, check that it is  
fitted before using the vehi-  
cle.  
Depending on the vehicle, the top of  
the headrest should be as close as  
possible to the top of the head.  
1.20  
REAR HEAD RESTS  
A
1
Positions for use  
To remove the headrest  
While pressing button A of lock 1, lift  
the headrest fully to use it in the top po-  
sition. Lower it until it locks to use it in  
the bottom position.  
Press button A of lock 1 and remove  
the headrest.  
To refit the headrest  
Insert the rods into the holes, press the  
tabs on both rods and lower the head-  
rest.  
Storage position  
Press button A and lower the headrest  
completely.  
When the headrest is set at the  
lowest position, this is for storage  
only. It should not be in this position  
when a seat is occupied.  
The headrest is a safety  
component, check that it is  
fitted and in the correct po-  
sition.  
1.21  
FRONT SEATS  
Heated seats  
With the ignition switched on, press  
switch 3 on the required seat. The indi-  
cator light in the switch lights up.  
The system, which has a thermostat,  
decides whether or not the heating is  
needed.  
2
3
1
To move forwards or  
backwards  
Adjusting the height of the  
driver’s seat  
Lift handle 1 underneath the seat to re-  
lease. Once in the desired position, re-  
lease the lever and check that the seat  
is correctly locked.  
Move lever 2 as many times as neces-  
sary:  
– upwards to raise it;  
– downwards to lower it.  
For safety reasons, carry  
out any adjustments when  
the vehicle is not being  
driven.  
1.22  
FRONT SEATS (continued)  
When a person, an object or a child  
seat prevents the front seats from lock-  
ing, perform the following operations:  
– ask all of the passengers to leave  
the vehicle and remove any bulky  
objects from the rear seats;  
4
– lock the seat(s) in the initial position  
again;  
– move the seat(s) forwards in order to  
create sufficient space;  
– ask the passengers to get back into  
the vehicle, and refit the child seat or  
objects on the rear seats.  
6
5
To tilt the seatback  
Turn control knob 5 and tilt the seat-  
Access to the rear seats  
three-door versions  
Check that nothing prevents  
the front seat from locking.  
If necessary, remove any  
obstructive objects.  
back to the desired position.  
Lift handle 6, tilt the seatback and slide  
the seat forwards.  
To return the seat to its original position  
(memorised position depending on ve-  
hicle):  
To adjust the lumbar support  
on the driver’s seat  
Pull handle 4.  
Repeat the above until the seat is  
locked correctly.  
– slide the seat backwards until it  
locks;  
Before starting the vehicle and be-  
ginning your journey, ensure that  
the seats are locked correctly.  
– lift the seatback until it locks.  
Risk of seat moving on its runners  
during vehicle acceleration or brak-  
ing.  
Make sure the seat is correctly locked  
in position.  
We would advise you not  
to recline the seatbacks too  
far to ensure that the effec-  
tiveness of the seat belts is  
not reduced.  
1.23  

Related Topics

Popular Owner Manuals