TYRE PRESSURE KIT (3/3)
– Start immediately and drive at a
speed between 12 to 37 mph (20 to
60 km/h) in order to distribute the
3
product evenly in the tyre; after driv-
ing a distance of 2 miles (3 km), stop
and check the pressure.
– If the pressure is higher than 1.3 bar
Please be aware that a
but lower than the recommended
poorly tightened or miss-
pressure (refer to the label affixed to
ing valve cap can make the
the edge of the driver’s door), adjust
tyres less airtight and may
it. Otherwise, contact an approved
lead to pressure loss.
dealer: the tyre cannot be repaired.
Always use valve caps identical to
those fitted originally and tighten
Precautions when using the
them fully.
kit
The kit should not be operated for more
Once the tyre is correctly inflated,
than 15 consecutive minutes.
remove the kit: unscrew the inflation
The container must be replaced after
Following repair with the kit,
adapter slowly from the container 3 to
the first use even if liquid remains
do not travel further than
prevent any product spatter and store
inside.
120 miles (200 km). In addi-
the container in plastic packaging to
tion, reduce your speed and
prevent product leaks.
under no circumstances exceed
– Affix the driving recommendation
48 mph (80 km/h). The sticker,
label (located under the container) to
which you must affix in a prominent
the dashboard where the driver can
position on the dashboard, reminds
see it.
you of this.
– Put the kit away.
Nothing should be placed
Depending on the country or local
– At the end of this initial inflation op-
around the driver’s feet
legislation, a tyre repaired with the
eration, air will still escape from the
as such objects may slide
inflation kit may need to be replaced.
tyre. You must drive a short distance
under the pedals during
in order to seal the hole.
sudden braking manoeuvres and
obstruct their use.
5.6