CHILD SEATS: fitted using the ISOFIX SYSTEM (3/6)
X = Seat not suitable for fitting child seats of this type.
IUF/IL = On equipped vehicles, seat which allows an approved
“Universal/semi-universal” or “vehicle specific” child seat to be at-
tached using the ISOFIX system; check that it can be fitted.
i-U = Suitable for “universal” front-facing and rear-facing i-Size
restraint devices.
i-UF = Suitable only for “universal” front-facing and rear-facing
i-Size restraint devices.
(1) Raise the seat to the maximum and position it as far back as
possible, tilting the seatback slightly (approximately 25°).
(2) If necessary, position the vehicle seat as far back as possible.
In order to install a rear-facing child seat, move the front seat
as far forward as possible, then move the front seat back as far
as it will go, without allowing it to come into contact with the
child seat.
(3) In all situations, remove the rear headrest of the seat on which
the child seat is positioned. This must be done before fitting the
child seat. ➥ 3.33. Move the seat in front of the child forwards, move the
seatback forward to avoid contact between the seat
and the child’s legs.
The size of the ISOFIX child seat is indicated by a letter:
– A, B, B1 [F3, F2, F2X]: for forward-facing seats in Group 1 (9 to 18
kg);
– CandD [R3,R2]: rear-facing seats or shell seats in Group 0+ (less than
13 kg) or Group 1 (9 to 18 kg);
– E [R1]: rear-facing shell seats in group 0 (less than 10 kg) or 0+
(less than 13 kg);
– F, G [L1, L2]: carrycots in group 0 (less
than 10 kg);
– [B2]: boosters in groups 2 and 3 (15 to 25 kg and 22 to 36 kg).
(4) RISK OF DEATH OR SERIOUS INJURY: before fitting a rear-facing child
seat in this seat, make sure that the front
passenger airbag has been deactivated. ➥ 1.57.
1.53
English 
