HEADLIGHT BEAM ADJUSTMENT
Examples of positions for
adjusting
control A according to the load
A
Driver alone or with front passenger
0
2
All seats occupied
Switch A is used to adjust the height of
the headlight beams according to the
load.
Driver with passengers and luggage
(or load) reaching the maximum
permissible all-up weight
3
4
With the dipped beam headlights lit,
press or lift switch A as many times
as is necessary to select the required
position on the instrument panel. The
position selected is displayed on the
instrument panel for approximately
30 seconds.
Driver without passengers and luggage
(or load) reaching the maximum
permissible all-up weight
Note: depending on the vehicle, at
each engine start-up the selected po-
sition may be displayed on the instru-
ment panel for approximately 30 sec-
onds.
The table below gives some examples. In all cases, adjust control
A accord-
ing to the vehicle load so that the road can be seen and other
drivers are not
dazzled.
1.106
English 
