GEAR LEVER
HANDBRAKE
POWER STEERING
To release:
When power assisted steering is
fitted, never leave the steering
wheel on full lock when the vehicle
is parked as this may damage the
pump.
Pull the lever up slightly, press
button 2 and then lower the lever to
the floor.
1
The red warning light on the
instrument panel will illuminate if
you are driving with an incorrectly
released handbrake.
2
To apply:
Pull the lever up.
The lever should travel about
10 notches to hold the car. Your
vehicle is fitted with self-adjusting
rear brake shoes and the handbrake
should only be adjusted during a
brake overhaul.
To select reverse
(vehicle stationary)
Move the lever to neutral, then
position the lever in reverse.
Ring 1 has to be lifted up to the gear
lever knob to select reverse gear.
When the vehicle is
stationary, make sure
that the handbrake is
properly applied so that
the vehicle does not move
unintentionally.
The reversing lights will illuminate
as soon as reverse gear is selected
(ignition on).
Never switch off the
ignition when travelling
Make sure the handbrake is
properly released when driving,
downhill, and avoid
otherwise
occur.
overheating
may
doing so when driving in
general (power steering and
brake servo will not function).
2.06
English 
