EXTERIOR LIGHTING AND SIGNALS (continued)
See-me-home lighting function
Turning off the lights
Manual operation
There are two possible ways
(depending on vehicle):
This function (useful, for example,
for opening a gate, a garage, etc.),
enables you to momentarily switch
on dipped beam headlights.
1
- return stalk
position,
1
to its original
With the engine switched off and
the lights off, the end of stalk 1 in
position 0, pull stalk 1 towards you:
the dipped beam headlights light up
for approximately thirty seconds.
- the lights go out when the engine
is stopped, when the driver's door
is opened or when the vehicle is
locked. In this case, the next time
the engine is started the lights will
be switched back according to the
position of the stalk 1.
This action may be carried out no
more than four times for
a
maximum lighting period of two
minutes.
Automatic operation (depending
on vehicle)
The lights go out when the engine is
stopped, when the driver's door is
opened or when the vehicle is
locked.
To switch off the lights before they
switch off automatically, turn the
end of stalk 1, then return it to
position 0.
Switching on the main
beam headlights
With the dipped beam headlights
on, pull stalk 1 towards you.
When the main beam headlights are
lit up, an indicator light on the
instrument panel comes on.
Lights on warning buzzer
If the lights are switched on after the
engine is switched off, a warning
buzzer sounds when the driver's
door is opened to warn you that the
lights are still on.
To return to the dipped headlight
position, pull the stalk towards you
again.
1.72
English 
