Get Driving -> Blind spot warning Guide for Renault Scenic 4 Door Fourth Generation (2017-2022)

BLIND SPOT WARNING (1/4)

1

A

This function is an addi-

tional aid which indicates

other vehicles in the blind

spot area.

This system alerts the driver to other

vehicles in the detection zone A.

Special feature

It can never in any case be a sub-

stitute for care nor for the driver’s

responsibility while in charge of his

vehicle.

Make sure that the sensors are not ob-

scured (by dirt, mud, snow, etc.).

If a sensor is obscured, the message

“Blind spot clean sensor” will appear on

the instrument panel. Clean the sen-

sors.

The system is activated when the vehi-

cle’s speed is between approximately

30 km/h (19 mph) and 140 km/h (87

mph).

The driver should always be ready

for sudden incidents while driv-

ing: always ensure that there are

no small, narrow moving obstacles

(such as a child, animal, pushchair,

bicycle, stone, post etc.) in the blind

spot when manoeuvring.

This function uses sensors 1 installed in

the front and rear bumper of both sides.

2.51

BLIND SPOT WARNING (2/4)

– repeatedly press the control 5 up or

down until you reach the Blind spot

alert menu, then press the switch 4

OK .

2

3

– press the 4 OK switch again to acti-

vate or deactivate the function.

4

5

Vehicles not fitted with a navigation

system

Activation/deactivation

Vehicles fitted with a navigation

system

– With the vehicle at a standstill, press

and hold the switch 4 OK to access

the settings menu;

On the multifunction screen 2, select

the “vehicle” menu, “Driving assist-

ance”, and “Blind spot alert”, and then

choose “ON” or “OFF”.

– repeatedly press the control 5 up or

down until you reach the “Driving as-

sistance” menu. Press the switch 4

OK;

You can access menu “Driving as-

sistance” directly from button 3

Whentheengineisstarted,thesystem

remembersitspositionwhentheigni-

tion was last switched off.



.

2.52

BLIND SPOT WARNING (3/4)

Display B

The function is activated and has not

detected any vehicles.

6

1

6

B

C

Display C

First warning: the indicator 6 means

that a vehicle has been detected in the

blind spot.

7

Display D

D

When the direction indicator is acti-

vated, the indicator light 6 flashes when

a vehicle is detected in the blind spot on

the side towards which you are about to

steer. If you cancel the direction indica-

tor, the function will return to the initial

warning (display C).

Indicator 6

An indicator light 6 is located on each

door mirror 7.

Operation

This function gives a warning:

– when the vehicle speed is between

approximately 19 mph (30 km/h) and

87 mph (140 km/h);

Note: clean the door mirrors 7 regularly

so that the indicators 6 can be seen.

– when another vehicle is in the blind

spot area and travelling in the same

direction as your vehicle.

If your vehicle is overtaking another ve-

hicle, the indicator 6 will be activated

only if that vehicle remains in the blind

spot for more than one second.

The system’s detection range oper-

ates according to a standard lane

width. If you are driving in narrow

traffic lanes, it may detect vehicles

in other lanes.

2.53

BLIND SPOT WARNING (4/4)

Operating faults

6

If the system detects a fault, the mes-

sage “Check blind spot alert” is dis-

played on the instrument panel. Consult

an approved dealer.

B

Note: when the engine is started, the

indicator light 6, display B, flashes

three times. It is normal.

C

D

– The system’s detection

range operates according

to a standard lane width. If

you are driving in wide traf-

fic lanes, the system might not

be able to detect a vehicle in the

blind spot.

Conditions for non-function

– If the object is not moving;

– if traffic is heavy;

– the road is winding;

– if front and rear sensors both detect

an object at the same time (e.g.

when passing an articulated lorry).

– The system might be disrupted

momentarily if it is exposed to

strong electromagnetic waves

(as beneath high-tension power

lines) or to very poor weather

conditions (heavy rain, snow

etc.). Remain aware of driving

conditions.

– ...

Because sensors have

been installed in the bump-

ers, any work (repairs, re-

placements, touching up of

paintwork) must be carried out by a

qualified professional.

There is a risk of accidents.

2.54

Driving -> Blind spot warning for Your Renault Scenic 4 Door Fourth Generation (2017-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals