Get Driving -> Lane Keeping Assist Guide for Renault Scenic 4 Door Fourth Generation (2017-2022)

LANE KEEPING ASSIST (1/4)

1

Note: make sure the windscreen is not

obscured (dirt, mud, snow, condensa-

tion etc.).

Using information from the camera 1,

the function is triggered if a contin-

uous or broken line is crossed without

activating the direction indicator lights,

with corrective action on the steering

system of the vehicle.

A notification on the instrument panel

appears to warn you of this.

This function is an addi-

tional driving aid. This func-

tion is not under any circum-

stances intended to replace

the due care and attention of the

driver, who should at all times be

in control of the vehicle.

On equipped vehicles, some infor-

mation is given on the head-up dis-

play.

2.47

LANE KEEPING ASSIST (2/4)

2

Operation

When the function is activated, the cor-

rection indicators 4 for the left and right

lines are displayed in grey on the instru-

ment panel.

3

The function is set to react if:

4

– speed is between about 43.4 mph

(70 km/h) and 99.2 mph (160 km/h);

and

– the correction indicators 4 are green.

The function reacts if the vehicle ap-

proaches or crosses a line without ac-

tivation of the indicator lights. In these

cases:

– the function triggers corrective action

on the vehicle’s steering system and

trajectory;

– the indicator 4 on the same side as

the crossed side line turns orange on

the instrument panel.

When Lane Keeping Assist is activated,

the “Lane Departure Warning” function

is automatically activated (please refer

to the information on “Lane Departure

Warning” in Section 2).

Activation/deactivation

From the multifunction screen 2: select

“Vehicle”, “Driving assistance”, “Lane

Keeping” then

“OFF" to deactivate it.



to activate or

Note: on bends, the function allows for

slightly cutting the bend.

You can access menu “Driving as-

sistance” directly from button 3

You can retake control of the ve-

hicle at any time by operating the

steering wheel.

The function is deactivated by de-

fault every time the engine is started.



.

2.48

LANE KEEPING ASSIST (3/4)

Special case

Adjustment

From the multifunction screen 2,

select “Vehicle”, “Driving assistance”,

“SETTINGS”:

2

When the function is set to react or it

reacts and cannot detect any further

action from the driver on the steering

wheel:

– the message “Keep control” appears

on the instrument panel;

– the right-hand and left-hand correc-

tion indicators turn orange;

– a beep sounds.

“SENSITIVITY”: adjust the sensitiv-

ity level for line detection. To do this,

select:

– “Low”: line detected when cross-

ing;

– “Average”: line detected on ap-

proach;

– “high”: line detected nearby.

If the driver does not take action, the

system may switch off the warnings

above and make the function unavail-

able until the next action of the driver on

the steering wheel.

Operating faults

In the event of a malfunction, the left-

hand and right-hand correction indica-

tors disappear or remain grey on the in-

strument panel.

In some cases, they are accompanied

by the message “Check Lane Keeping”

^{or the}© warning light on the in-

strument panel.

– only one line is detected;

– very fast lane departure;

– driving continuously near a line;

– impaired visibility;

– 4 seconds approximately after

changing lanes;

– during tight bends;

– the lane width is too narrow;

– ...

Conditions in which the

function is not available

– Correction indicators activated or

having been activated approximately

four seconds prior to crossing the

line;

Consult an approved dealer.

– the driver’s hands are not on the

steering wheel;

When the function is unavailable, the

correction indicators are displayed in

grey on the instrument panel.

2.49

LANE KEEPING ASSIST (4/4)

This function is an additional driving aid. This function is not under any circumstances intended to replace the due care

and attention of the driver, who should at all times be in control of the vehicle.

System servicing/repairs

– In the event of an impact, the camera alignment may be changed, and its operation may consequently be affected. Deactivate

the function and consult an authorised dealer.

– Any work in the area where the camera is located (repairs, replacements, windscreen modifications etc.) must be carried

out by a qualified professional.

Only an authorised dealer is qualified to service the system.

In the event of system disturbance

Some conditions can disturb or damage the operation of the system, such as:

– windscreen obscured (by dirt, ice, snow, condensation etc.);

– a complex environment (tunnel etc.);

– poor weather conditions (snow, hail, black ice etc.);

– poor visibility (night, fog etc.);

– road markings which are worn, lacking in contrast or very widely spaced from one another (lines partially erased etc);

– being dazzled (glaring sun, lights of vehicles travelling in the opposite direction etc.);

– the road is narrow, winding or undulating (tight bends etc.);

– closely following a vehicle travelling in the same lane.

In this case, the “Lane Keeping Assist” may react incorrectly or not at all.

Risk of unwanted, incorrect correction or no correction of trajectory.

Deactivating the function

You must disable the function if:

– the area of the camera has been damaged (on the windscreen side or the interior rear-view mirror side);

– the road is slippery (snow, black ice, aquaplaning, gravel etc.) ;

– poor visibility (night, fog etc.);

– the windscreen is cracked or distorted (do not carry out windscreen repairs in this area; have it changed by an Authorised

Dealer);

– the vehicle is towing a trailer or a caravan;

– the vehicle is entering an area with several surface markings (an area with road works etc.).

2.50

Driving -> Lane Keeping Assist for Your Renault Scenic 4 Door Fourth Generation (2017-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals