Get Driving -> Electronic parking brake Guide for Renault Scenic 4 Door Fourth Generation (2017-2022)

ELECTRONIC PARKING BRAKE (1/4)

In all other circumstances, for example,

stalled engine or engine switched to

standby by the Stop and Start func-

tion (refer to the information on the

“Stop and Start function” in Section 2),

the electronic parking brake is not ap-

plied automatically. Manual mode must

be used.

1

4

For certain country-specific model ver-

sions, the assisted brake application

function is not activated. Refer to the

information on “Manual operation”.

3

To confirm that the electronic parking

brake is applied, the message “Parking

2

brake on” is displayed, the

}

warn-

or

ing light appears on the instrument

panel and the 4 warning light appears

on the 3 switch.

After the engine is switched off, indi-

cator light 4 goes out several minutes

after the assisted parking brake has

Assisted operation

– for vehicles fitted with an automatic

gearbox, when position P is en-

gaged.

Applying the electronic parking

brake

With the vehicle stationary, the elec-

tronic parking brake can be used to im-

mobilise the vehicle:

– by pressing the engine start/stop

button 1 or by turning the ignition

key 2 (to the “ON” position 2);

or

been applied and indicator light

goes out when the vehicle is locked.

}

– when the driver’s seat belt is un-

fastened;

or

Before leaving the vehicle, check that the electronic parking brake is fully

applied. Warning light 4 on switch 3 and warning light on the in-

strument panel illuminate to show that the parking brake is applied but

switch off when the doors are locked.

– when the driver’s door is opened;

}

2.16

ELECTRONIC PARKING BRAKE (2/4)

Manually releasing the electronic

parking brake

Assisted operation

(continued)

Press switch 1 without pressing the

pedals or turning the key 2 to position

“ON” 2 to switch on the ignition. Press

the brake pedal then press switch 3: in-

dicator light 4 on the switch and indica-

Note: in some situations (electronic

parking brake failure, manual release of

the parking brake, etc.), a beep sounds

and the message “Apply parking brake”

appears on the instrument panel to

warn you that the electronic parking

brake has been released.

– with the engine running: when the

driver’s door is opened;

– with the engine switched off (e.g.

when the engine stalls): when a front

door is opened.

4

tor light

ment panel go out.

}

displayed on the instru-

3

Brief stop

To apply the electronic parking brake

manually (when stopping at a red light,

or stopping when the engine is running,

etc.): pull and release the switch 3. The

brake is released as soon as the vehi-

cle is started up again.

In this case, pull and release switch 3 to

apply the assisted parking brake.

Manual operation

You can apply the electronic parking

brake manually.

Assisted release of the parking

brake

Manually applying the electronic

parking brake

The brake will be released as soon as

the vehicle starts and accelerates.

Pull switch 3. Warning light 4 and warn-

ing light

light up.

}

on the instrument panel

Before leaving the vehicle,

check that the electronic

parking brake is fully ap-

plied. Warning light 4 on

switch 3 and warning light

}

on

the instrument panel illuminate to

show that the parking brake is ap-

plied but switch off when the doors

are locked.

2.17

ELECTRONIC PARKING BRAKE (3/4)

To park the vehicle without applying the

electronic parking brake (if there is a

risk of freezing, for example):

– switch off the engine by pressing the

engine start/stop button 1 or by turn-

ing the ignition key 2;

4

– manually release the electronic park-

ing brake;

– with a gear or position P engaged,

release the brake pedal and the

switch 3.

3

Special cases

To park on a slope or while towing a

trailer, for example, pull switch 3 for

a few seconds to gain the maximum

braking.

2.18

ELECTRONIC PARKING BRAKE (4/4)

Versions with an automatic

Operating faults

gearbox

light illuminates on the instrument

panel accompanied by the “Check

parking brake” message and, in

For safety reasons, automatic release

is deactivated when the driver’s door

is open or not shut properly and the

engine is running (in order to prevent

the vehicle from moving without the

driver). The “Release parking brake

manually” message appears on the

instrument panel when the driver de-

presses the accelerator.

If the message “Electric fail-

ure DANGER” or “Check

battery” appears, manually

activate the electronic park-

ing brake by pulling switch 3 (or po-

sition the gear lever in P for auto-

matic gearboxes) before stopping

the engine.

some cases, the

light.

Contact your approved Dealer

straight away.

}

warning

– If there is an assisted parking brake

^{fault, the warning light}® comes

on, along with the message “Braking

system fault”, a beep and, in some

Risk of loss of immobilisation of

the vehicle.

cases, the warning light

}

.

Call an approved Dealer.

This means that you must stop as

soon as traffic conditions allow.

Never leave your vehicle

without moving the selec-

tor lever to position P and

If no lights or sounds are ap-

parent, this indicates a fault

in the instrument panel. This

It is therefore essential to

immobilise the vehicle by

engaging first gear (manual

gearbox) or position P (au-

tomatic gearbox). If the slope re-

quires it, chock the vehicle.

switching off the engine.

indicates that it is essential

This is because when the vehicle is

stationary with the engine running

and a gear engaged, the vehicle

may begin to move.

to stop immediately (as soon as traf-

fic conditions allow). Ensure that the

vehicle is correctly immobilised and

contact an approved Dealer.

There is a risk of accidents.

2.19

Driving -> Electronic parking brake for Your Renault Scenic 4 Door Fourth Generation (2017-2022)

Related Topics

Popular Owner Manuals

Latest Owner Manuals