Lighting, windscreen wipers and washers › Dynamic Light Assist headlight assist system 51
Operating conditions
✓ The system is activated.
Operating conditions
✓ The system is activated.
✓
✓
The light switch is in the
position.
The light switch is in the
position.
✓ The driving speed is higher than 30 km/h.
✓ The low beam is switched on.
✓ The driving speed is higher than 30 km/h (for
some countries, higher than 60 km/h).
✓ The low beam is switched on.
Operation
Operation
Switching on
Switching on
Push the lever in the
direction of the arrow.
›
Push the lever in the
direction of the arrow.
›
It lights up in the instru-
It lights up in the instru-
ment cluster
from
the isolation box.
ment cluster
the isolation box.
from
Switching off
Manually switch the high beam on or off.
Switching off
Manually switch the high beam on or off.
›
›
Function restriction
Function restriction
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example:
The system may dazzle other road users if their
headlights/lights are not detected for the following
reasons, for example:
The headlights/lights of oncoming vehicles are
covered by crash barriers, for example.
▶
The headlights/lights of oncoming vehicles are
covered by crash barriers, for example.
▶
The headlamps/lights of the oncoming or preced-
ing vehicle are dirty or not functioning.
▶
The headlamps/lights of the oncoming or preced-
ing vehicle are dirty or not functioning. The system
can also recognize a vehicle as a single-lane means
of transport.
▶
Settings
Activation/deactivation
The function is activated or deactivated in the fol-
lowing menu in the Infotainment system:
Settings
Activation/deactivation
The Dynamic Light Assist is activated or deactivated
in the following menu in the Infotainment system:
Or:
Or:
Dynamic Light Assist headlight assist
system
Functionality
Replace light bulbs
The headlight assist system automatically switches
the high beam on and off.
What you should be mindful of
DIY replacement of the following bulbs is possible.
Have the remaining light sources replaced by a spe-
cialist garage.
When the high beam is switched on, it adjusts the
light cone so that the drivers of oncoming and pre-
ceding vehicles are not dazzled.
The new bulb must conform to the specification of
the original light bulb. The name of the bulb is
marked on the bulb socket.
WARNING
Risk of accident!
If necessary, manually switch the high beam on or
▶
off.
English 
