2010-2016 Subaru XV SUV Keys and doors -> Passive arming User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Keys and doors -> Passive arming for Your Subaru XV SUV First Generation (2010-2016)

2-13Keys and doors/Alarm systemsecurity indicator light will then change11. The security indicator light will con-slowly (once approximately every 3 sec-tinue to flash once every 3 secondsonds from twice approximately every 2indicating that the system is in the valetseconds), indicating that the alarm been exit valet mode, change the setting ofNOTEyour vehicle’s alarm system for activationmode. Refer to “Activating and deactivat-After disarming the alarm system,ing the alarm system” press the “ ” button a secondtime within 5 seconds to unlock all& Passive armingother doors and the rear gate (5-door).! Passive arming mode! Emergency disarmingWhen passive arming mode has beenIf you cannot disarm the system using the6. Press the front side (“LOCK” side) ofprogrammed by the dealer, arming of thetransmitter (i.e. the transmitter is lost,the power door locking switch to set thesystem is automatically accomplishedbroken or the transmitter battery is toodoor using the remote transmitter. Noteweak), you can disarm the system without7. Close the door. An electronic chirp willthat in this mode, DOORS MUST BEusing the transmitter as once, the hazard warning flashersMANUALLY LOCKED.. Turn the ignition switch from thewill flash once and the security indicator! To enter the passive mode“LOCK” (off) to the “ON” position with alight will start flashing rapidly. After rapidregistered you wish to program the passive armingflashing for 30 seconds (standby time), themode, have it done by your SUBARUindicator lights will then flash slowly (twice& Valet every 2 seconds), indicat-ing that the system has been armed forWhen you choose the valet mode, the! Arming the system does not operate. In valetmode, the remote transmitter is used onlyCAUTION& Disarming the systemfor locking and unlocking the doors andrear gate (5-door) and panic passive mode, the sy
2-13
Keys and doors/Alarm system
security indicator light will then change
11. The security indicator light will con-
slowly (once approximately every 3 sec-
tinue to flash once every 3 seconds
onds from twice approximately every 2
indicating that the system is in the valet
seconds), indicating that the alarm system
mode.
has been disarmed.
To exit valet mode, change the setting of
NOTE
your vehicle’s alarm system for activation
mode. Refer to “Activating and deactivat-
After disarming the alarm system,
ing the alarm system” F2-11.
briefly press the “ ” button a second
time within 5 seconds to unlock all
& Passive arming
other doors and the rear gate (5-door).
! Passive arming mode
! Emergency disarming
When passive arming mode has been
If you cannot disarm the system using the
6. Press the front side (“LOCK” side) of
programmed by the dealer, arming of the
transmitter (i.e. the transmitter is lost,
the power door locking switch to set the
system is automatically accomplished
broken or the transmitter battery is too
door locks.
without using the remote transmitter. Note
weak), you can disarm the system without
7. Close the door. An electronic chirp will
that in this mode, DOORS MUST BE
using the transmitter as follows.
sound once, the hazard warning flashers
MANUALLY LOCKED.
. Turn the ignition switch from the
will flash once and the security indicator
! To enter the passive mode
“LOCK” (off) to the “ON” position with a
light will start flashing rapidly. After rapid
registered key.
If you wish to program the passive arming
flashing for 30 seconds (standby time), the
mode, have it done by your SUBARU
indicator lights will then flash slowly (twice
& Valet mode
dealer.
approximately every 2 seconds), indicat-
ing that the system has been armed for
When you choose the valet mode, the
! Arming the system
surveillance.
alarm system does not operate. In valet
mode, the remote transmitter is used only
CAUTION
& Disarming the system
for locking and unlocking the doors and
rear gate (5-door) and panic activation.
In passive mode, the system will
Briefly press the “ ” button (for less than
automatically activate the alarm but
2 seconds) on the remote transmitter. The
To enter the valet mode, change the
WILL NOT automatically lock the
driver’s door will unlock, an electronic
setting of your vehicle’s alarm system for
doors. In order to lock the doors
chirp will sound twice, the hazard warning
deactivation mode. Refer to “Activating
you must either lock them as in-
flashers will flash twice. The flashing of the
and deactivating the alarm system” F2-
– CONTINUED –
2-14 Keys and doors/Alarm system& Tripped sensor identificationdicated in step 4 below or with thekey once they have been security indicator light flashes whenFailure to lock the doors manuallythe alarm system has been result in a higher security , the number of flashes indicates thelocation of unauthorized intrusion or the1. Turn the ignition switch to the “ON”severity of impact on the the ignition switch is turned to the“ON” position, the indicator light will lightfor 1 second and then flash as follows.. When a door or the rear gate (5-door)was opened: 5 times. When a door or the trunk (4-door) was4. Before closing the doors, lock all doorsopened: 4 timeswith the inside door lock levers.. When the ignition switch was turned to5. Close the doors. The system willthe “ON” position: 3 timesautomatically arm after 1 minute.. When a strong impact or multipleimpacts were sensed: twice (only modelsIn the passive mode, the system can alsowith shock sensors (dealer option))be armed with the remote transmitter or. When a light impact was sensed: oncewith the power door locking switches. If1)ON(only models with shock sensors (dealerthe remote transmitter or power door2)LOCK (off)option))locking switch is used to lock the vehicle,2. Turn the ignition switch from “ON” toarming will take place immediately regard-NOTE“LOCK” (off) position and remove the keyless of whether or not the passive modeAny of the above indicator light flash-from the ignition been will recur each time the ignition3. Open the doors and get out of the! Disarming the systemswitch is turned to the “ON” disarm the system, briefly press theRearming the alarm system cancels the“ ” button on the .
2-14 Keys and doors/Alarm system
& Tripped sensor identification
dicated in step 4 below or with the
key once they have been closed.
The security indicator light flashes when
Failure to lock the doors manually
the alarm system has been triggered.
will result in a higher security risk.
Also, the number of flashes indicates the
location of unauthorized intrusion or the
1. Turn the ignition switch to the “ON”
severity of impact on the vehicle.
position.
When the ignition switch is turned to the
“ON” position, the indicator light will light
for 1 second and then flash as follows.
. When a door or the rear gate (5-door)
was opened: 5 times
. When a door or the trunk (4-door) was
4. Before closing the doors, lock all doors
opened: 4 times
with the inside door lock levers.
. When the ignition switch was turned to
5. Close the doors. The system will
the “ON” position: 3 times
automatically arm after 1 minute.
. When a strong impact or multiple
impacts were sensed: twice (only models
In the passive mode, the system can also
with shock sensors (dealer option))
be armed with the remote transmitter or
. When a light impact was sensed: once
with the power door locking switches. If
1)
ON
(only models with shock sensors (dealer
the remote transmitter or power door
2)
LOCK (off)
option))
locking switch is used to lock the vehicle,
2. Turn the ignition switch from “ON” to
arming will take place immediately regard-
NOTE
“LOCK” (off) position and remove the key
less of whether or not the passive mode
Any of the above indicator light flash-
from the ignition switch.
has been selected.
ings will recur each time the ignition
3. Open the doors and get out of the
! Disarming the system
switch is turned to the “ON” position.
vehicle.
To disarm the system, briefly press the
Rearming the alarm system cancels the
“ ” button on the transmitter.
flashing.

Related Topics

Popular Owner Manuals