2-14 Keys and doors/Alarm system
& Tripped sensor identification
dicated in step 4 below or with the
key once they have been closed.
The security indicator light flashes when
Failure to lock the doors manually
the alarm system has been triggered.
will result in a higher security risk.
Also, the number of flashes indicates the
location of unauthorized intrusion or the
1. Turn the ignition switch to the “ON”
severity of impact on the vehicle.
position.
When the ignition switch is turned to the
“ON” position, the indicator light will light
for 1 second and then flash as follows.
. When a door or the rear gate (5-door)
was opened: 5 times
. When a door or the trunk (4-door) was
4. Before closing the doors, lock all doors
opened: 4 times
with the inside door lock levers.
. When the ignition switch was turned to
5. Close the doors. The system will
the “ON” position: 3 times
automatically arm after 1 minute.
. When a strong impact or multiple
impacts were sensed: twice (only models
In the passive mode, the system can also
with shock sensors (dealer option))
be armed with the remote transmitter or
. When a light impact was sensed: once
with the power door locking switches. If
1)
ON
(only models with shock sensors (dealer
the remote transmitter or power door
2)
LOCK (off)
option))
locking switch is used to lock the vehicle,
2. Turn the ignition switch from “ON” to
arming will take place immediately regard-
NOTE
“LOCK” (off) position and remove the key
less of whether or not the passive mode
Any of the above indicator light flash-
from the ignition switch.
has been selected.
ings will recur each time the ignition
3. Open the doors and get out of the
! Disarming the system
switch is turned to the “ON” position.
vehicle.
To disarm the system, briefly press the
Rearming the alarm system cancels the
“ ” button on the transmitter.
flashing.
English 
