1995-2002 Suzuki Baleno 4 Door Inspection and Maintenance -> Battery User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Inspection and Maintenance -> Battery for Your Suzuki Baleno 4 Door First Generation (1995-2002)

7-44
INSPECTION AND MAINTENANCE
68PM2-01E
54G118
For maintenance-free battery (cap-less
type), you need not add water. For tradi-
tional type battery, which has water filler
caps, the level of the battery solution must
be kept between “MAX” and “MIN” level
lines at all times. If the level is found to be
below “MIN” level line, add distilled water
to “MAX” level line. You should periodically
check the battery, battery terminals, and
battery hold-down bracket for corrosion.
Remove corrosion using a stiff brush and
ammonia mixed with water, or baking soda
mixed with water. After removing corro-
sion, rinse with clean water.
If your vehicle is not going to be driven for
a month or longer, disconnect the cable
from the negative terminal of the battery to
help prevent discharge.
Replacement of the battery
(For vehicles without ENG A-STOP sys-
tem)
68PM00711
(For vehicles with ENG A-STOP system)
68PM00712
To remove the battery:
1) Disconnect the negative cable (1).
2) Disconnect the positive cable (2).
For vehicles without ENG A-STOP sys-
tem;
3) Remove the retainer nuts (3) and
remove the retainer (4).
For vehicles with ENG A-STOP system;
3) Remove the bracket bolt (3) and
remove the bracket (4).
4) Remove the battery.
To install the battery:
1) Install the battery in the reverse order of
removal.
2) Tighten the bracket bolt and battery
cables securely.
EXAMPLE
(1)
(2)
(3)
(4)
EXAMPLE
(1)
(2)
(3)
(4)
EXAMPLE
7-45
INSPECTION AND MAINTENANCE
68PM2-01E
NOTE:
• When the battery is disconnected, some
of the vehicle’s functions will be initial-
ized and/or deactivated.
These functions must be required to
reset after the battery is reconnected.
• Do not disconnect the battery terminals
for at least one minute after the ignition
switch is turned off, or the engine switch
is pressed to change the ignition mode
to “LOCK” (OFF).
(Battery label)
51KM042
(5) Crossed-out wheeled bin symbol
(6) Chemical symbol of “Pb”
The crossed-out wheeled bin symbol (5)
located on the battery label indicates that
the used battery should be collected sepa-
rately from ordinary household trash.
The chemical symbol of “Pb” (6) indicates
the battery contains more than 0.004%
lead.
By ensuring the used battery is disposed
of or recycled correctly, you will help pre-
vent potential negative consequences for
the environment and human health, which
could otherwise be caused by inappropri-
ate trash handling of the battery. The recy-
cling of materials will help to conserve
natural resources. For more detailed infor-
mation about disposing of or recycling the
used battery, consult your SUZUKI dealer.
WARNING
Batteries contain toxic substances
including sulfuric acid and lead. They
could have potential negative conse-
quences for the environment and
human health. Used batteries must
be disposed of or recycled according
to applicable rules or regulations and
must not be disposed of with ordi-
nary household trash. Make sure not
to tip over the battery when you
remove it from the vehicle. Other-
wise, sulfuric acid could run out and
you might get injury.
NOTICE
After stopping the engine, controller
and system are operated for a while.
Therefore, before removing the bat-
tery, wait for more than one minute
after turning the ignition switch to
“OFF” or changing the ignition mode
to “LOCK” (OFF).
Pb
(5)
(6)

Related Topics

Popular Owner Manuals