2000-2008 Suzuki Ignis SUV Before Driving -> Windows User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Before Driving -> Windows for Your Suzuki Ignis SUV First Generation (2000-2008)

2-18
BEFORE DRIVING
4) Turn the knob on the lighting control
lever to the position and then turn
back to the OFF position. Repeat this
operation 4 times.
66RH017
5) Push the lock end (4) (forward end) of
the central door locking switch (5), and
then push the unlock end (6) (backward
end). Repeat this operation 3 times.
Every time you perform the series of the
above steps, the state of the security sys-
tem changes from the currently selected
one to the other. You can check whether
the system is enabled or disabled by the
number of interior buzzer beeps at the end
of the procedure as follows.
• If you cannot complete the operations in
step 4) and 5) within 15 seconds cor-
rectly, the state of the security system
will not change and the interior buzzer
does not beep. Perform the procedure
again from the beginning.
NOTE:
You can also switch the security system
from the enabled state to the disabled
state, and vice versa, via the setting mode
of the information display. For details on
how to use the information display, refer to
“Information display” in this section.
Windows
Manual window control
(if equipped)
60G010A
Raise or lower the door windows by turning
the handle located on the door panel.
(5)
(4)
(6)
EXAMPLE
3 times
System state Number of beeps
Disabled
(Mode A)
Once
Enabled
(Mode D)
4 times
EXAMPLE
2-19
BEFORE DRIVING
Electric window controls
(if equipped)
The electric windows can only be operated
when the ignition switch is in “ON” position
or the ignition mode is ON.
Driver’s side (Type A)
66RH018
Driver’s side (Type B)
66RH019
The driver’s door has a switch (1) to oper-
ate the driver’s window, and a switch (2) to
operate the front passenger’s window or
there are switches (3), (4), to operate the
rear right and left passenger windows,
respectively.
Passenger’s door
66RH020
The passenger’s door has a switch (5) to
operate the passenger’s window.
(1)
(2)
EXAMPLE
(3)
(4)
(1)
(2)
EXAMPLE
(5)
EXAMPLE
2-20
BEFORE DRIVING
81A009
To open a window, push the top part of the
switch. To close the window, lift up the top
part of the switch.
The driver’s window has AUTO-DOWN
feature for greater convenience (at toll
booths or drive-through restaurants, for
example). This means the driver can open
the window without holding the window
switch in DOWN position. Press down the
driver’s window switch completely and
release it. To stop the window before it
reaches the FULL-DOWN position, pull up
the switch briefly.
Lock switch (Type A)
66RH021
Lock switch (Type B)
66RH022
The driver’s door also has a lock switch for
the passenger’s window(s). When you
push in the lock switch, the passenger’s
window(s) cannot be raised or lowered by
operating any of the switches (2), (3), (4)
or (5). To restore normal operation, release
the lock switch by pushing it again.
NOTE:
If you drive with one of the rear windows
open, you may hear a loud sound caused
by air vibration. To reduce the sound, open
the driver’s or front passenger’s window, or
narrow the rear window opening.
CLOSE
OPEN
EXAMPLE
EXAMPLE
EXAMPLE
WARNING
• You should always lock the pas-
senger’s window operation when
there are children in the vehicle.
Children can be seriously injured if
they get part of their body caught
by the window during operation.
• To avoid injuring an occupant by
window entrapment, make sure
that no part of the occupant’s body
such as hands or head is in the
path of the electric windows when
closing them.
• Always remove the ignition key or
take the keyless push start system
remote controller with you when
leaving the vehicle even only for a
short time. Also do not leave chil-
dren alone in a parked vehicle.
Unattended children could use the
electric window switches and get
trapped by the window.

Related Topics

Popular Owner Manuals