2023-2026 Suzuki Swift 4 Door OPERATING YOUR VEHICLE -> Braking User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

OPERATING YOUR VEHICLE -> Braking for Your Suzuki Swift 4 Door Fourth Generation (2023-2026)

OPERATING YOUR VEHICLE  
WARNING  
Cancelling cruise control  
Braking  
“SET” indicator light (5) will go off and the  
cruise control will be canceled temporarily  
with the following conditions:  
If water gets into the brake devices,  
brake performance may become poor  
and unpredictable. After driving  
through water or washing the under-  
side of the vehicle, test the brakes  
while driving at a slow speed to see if  
they have maintained their normal  
effectiveness. If the brakes are less  
effective than normal, dry them by  
repeatedly applying the brakes while  
driving slowly until the brakes have  
regained their normal effectiveness.  
• Push “CANCEL” switch (2).  
• Depress the brake pedal.  
• The gear position is changed to “L”  
• The vehicle speed falls more than about  
20 percent from the set speed.  
• Any time the vehicle speed falls below  
40 km/h (25 mph).  
®
• When the vehicle skids and ESP is  
activated.  
To resume the previously set speed, push  
up the “RES +/SET –” switch (3) and turn  
on “SET” indicator light (5). The vehicle  
speed must be above 40 km/h (25 mph)  
when the vehicle is not under the above  
conditions.  
Power-assisted brakes  
60G165S  
Your vehicle has power-assisted brakes. If  
power assistance is lost due to a stalled  
engine or other failures, the system is still  
fully operational on reserve power and you  
can bring the vehicle to a complete stop by  
pressing the brake pedal once and holding  
it down. The reserve power is partly used  
up when you depress the brake pedal and  
reduces each time the pedal is pressed.  
Apply smooth and even pressure to the  
pedal. Do not pump the pedal.  
The distance needed to bring any vehicle  
to a halt increases with the speed of the  
vehicle. The braking distance needed, for  
example, at 60 km/h (37 mph) will be  
approximately 4 times greater than the  
braking distance needed at 30 km/h (19  
mph). Start to depress the brake pedal  
when there is plenty of distance between  
your vehicle and the stopping point, and  
slow down gradually.  
To turn off the cruise control system, push  
cruise switch (1) and check that the cruise  
indicator light (4) is off.  
Also, if the malfunction indicator light in the  
instrument cluster comes on or blinks, the  
cruise control system will be turned off.  
NOTE:  
If you turn off the cruise control system, the  
previously set speed in the memory is  
cleared. Reset your cruising speed again.  
3-24  
OPERATING YOUR VEHICLE  
WARNING  
it senses that the wheels are locking up.  
You may feel the brake pedal move a little  
while the ABS is operating.  
WARNING  
Even without reserve power in the  
brake system, you can still stop the  
vehicle by pressing the brake pedal  
harder than normally required. How-  
ever, the stopping distance may be  
longer.  
(Continued)  
NOTE:  
• On regular paved roads, some driv-  
ers may be able to obtain slightly  
shorter stopping distances with  
conventional brake systems than  
with ABS.  
• In both of the above conditions,  
ABS will still offer the advantage of  
helping you maintain directional  
control. However, remember that  
ABS will not compensate for bad  
road or weather conditions or poor  
driver judgment. Use good judg-  
ment and do not drive too fast.  
• The ABS will not work if vehicle speed is  
under about 9 km/h (6 mph).  
• If the ABS system is activated, you may  
hear a clunking noise and/or feel pulsat-  
ing in the brake pedal. This is normal  
and indicates that the brake fluid pres-  
sure is being controlled properly.  
• You may hear an operation sound when  
you start the engine or after the vehicle  
begins to move. This means that the  
above systems are in the self-check  
mode. This sound does not indicate a  
malfunction.  
Brake assist system  
When you slam the brakes on, the brake  
assist system determines it to be an emer-  
gency stop and provides more powerful  
braking for a driver who cannot hold down  
the brake pedal firmly.  
NOTE:  
WARNING  
If you quickly and forcefully depress the  
brakes, you may hear a clicking sound in  
the brake pedal. This is normal and indi-  
cates that the brake assist system is acti-  
vated properly.  
• On some types of loose surfaces  
(such as gravel, snow-covered  
roads, etc.), the stopping distance  
required for a vehicle with ABS  
may be slightly greater than the  
one required for a comparable vehi-  
cle with a conventional brake sys-  
tem. With a conventional brake  
system, skidding tires are able to  
plow the gravel or snow layer,  
shortening the stopping distance.  
ABS minimizes this resistance  
effect. Allow for extra stopping dis-  
tance when driving on loose sur-  
faces.  
Anti-lock brake system (ABS)  
(1)  
(2)  
ABS will help you avoid skidding by elec-  
tronically controlling braking pressure. It  
will also help you maintain steering control  
when braking on slippery surfaces or when  
braking hard.  
The ABS works automatically, so you do  
not need any special braking technique.  
Just push the brake pedal down without  
pumping. The ABS will operate whenever  
54MN069  
(1) ABS warning light  
(2) Brake system warning light  
(Continued)  
3-25  

Related Topics

Popular Owner Manuals