AIR CONDITIONING -> Air Inlet Servomotor for Your Toyota Avensis 4 Door First Generation (1997-2003)

AC–15  
AIR CONDITIONING  
AIR INLET SERVOMOTOR  
AIR INLET SERVOMOTOR  
AC39I–01  
COMPONENTS  
Blower Unit  
Air Duct  
Engine (and ECT) ECU  
Cowl Side Trim  
Lower Finish Panel  
Front Door Scuff Plate  
No. 2 Under Cover  
Blower Unit Case  
Air Inlet Servomotor  
I18810  
AVENSIS/CORONA SUP (RM781E)  
AC–16  
AIR CONDITIONING  
AIR INLET SERVOMOTOR  
AC39J–01  
REMOVAL  
1.  
REMOVE FRONT DOOR SCUFF PLATE ON PAS-  
SENGER SIDE  
2.  
3.  
4.  
5.  
REMOVE COWL SIDE TRIM ON PASSENGER SIDE  
REMOVE NO. 2 UNDER COVER  
REMOVE LOWER FINISH PANEL (See page BO–8)  
REMOVE ENGINE (and ECT) ECU  
6.  
RHD Models Only:  
REMOVE THEFT DETERRENT ECU  
(a) Disconnect the connector.  
(b) Remove the 2 screws and ECU.  
I03586  
I03585  
N04901  
7.  
REMOVE AIR DUCT  
Remove the 2 screws and duct.  
8.  
REMOVE BLOWER UNIT  
(a) Disconnect the connectors.  
(b) Remove the bolt, screw and nut.  
(c) Remove the blower unit.  
9.  
REMOVE AIR INLET SERVOMOTOR  
Remove the 3 screws and air inlet servomotor.  
AVENSIS/CORONA SUP (RM781E)  
AC–17  
AIR CONDITIONING  
AIR INLET SERVOMOTOR  
AC39K–01  
”REC”  
”FRS”  
”REC”  
”FRS”  
INSPECTION  
1.  
LHD:  
INSPECT AIR INLET SERVOMOTOR OPERATION  
7
1
(a) Connect the positive (+) lead from the battery to terminal  
7 and negative (–) lead to terminal 1 and check that arm  
turns to ”REC” side smoothly.  
If operation is not as specified, replace the servomotor.  
I19376  
I19377  
I18814  
I18815  
(b) Connect the positive (+) lead from the battery to terminal  
7 and the negative (–) lead to terminal 3 and check that  
the arm turns to ”FRS” side smoothly.  
7
3
If operation is not as specified, replace the servomotor.  
2.  
RHD:  
INSPECT AIR INLET SERVOMOTOR OPERATION  
7
1
(a) Connect the positive (+) lead from the battery to terminal  
7 and negative (–) lead to terminal 1 and check that arm  
turns to ”REC” side smoothly.  
If operation is not as specified, replace the servomotor.  
(b) Connect the positive (+) lead from the battery to terminal  
7 and the negative (–) lead to terminal 3 and check that  
the arm turns to ”FRS” side smoothly.  
7
3
If operation is not as specified, replace the servomotor.  
AVENSIS/CORONA SUP (RM781E)  
AC–18  
AIR CONDITIONING  
AIR INLET SERVOMOTOR  
AC39L–01  
INSTALLATION  
Installation is in the reverse order of removal (See page AC–16).  
AVENSIS/CORONA SUP (RM781E)