Advanced Driving Assistance Systems -> Tyre deflation detection system for Your Vauxhall Frontera SUV Third Generation (2024-2026)

Advanced Driving Assistance Systems  
133  
The preset speed can be changed  
Resume limit speed  
Switching on the system  
by pressing to increase or  
Press  
or  
/
to decrease the speed. A short press  
changes speed by 0.5 mph, a long press  
changes speed by 3 mph.  
Switching off the system  
Press  
, the speed limiter mode is  
Press  
or  
to activate.  
deselected and the speed limit indication  
extinguishes.  
Press  
ignition cycle.  
to activate within the same  
Fault  
Exceeding the speed limit  
In the event of a speed limiter fault, the  
speed is cleared resulting in flashing of  
the dashes.  
Have the system checked by a  
workshop.  
In the event of an emergency, it is  
possible to exceed the speed limit by  
depressing the accelerator pedal firmly to  
the final point. In this case, the preset  
speed value flashes.  
Press  
twice to activate speed limiter.  
Release the accelerator pedal and the  
speed limiter function is reactivated once  
a speed lower than the limit speed is  
obtained.  
Activation of the functionality  
Setting speed by the driver  
Tyre deflation detection  
system  
The tyre deflation detection system  
continually checks the rotation speed  
of all four wheels and warns on low  
tyre pressure condition once vehicle is  
driving. This is achieved by comparing  
tyre rolling circumference with reference  
values and further signals.  
Deactivation of the functionality  
Press  
mode.  
, speed limiter is in pause  
The vehicle is driven without speed  
limiter.  
Speed limiter is deactivated, but not  
switched off. Last stored speed remains  
in memory for later speed resume.  
If a tyre loses pressure the control  
indicator  
illuminates and a warning  
message is displayed on the cluster.  
Control indicator ðpage51  
134  
Advanced Driving Assistance Systems  
In this case reduce speed, avoid sharp  
cornering and strong braking.  
3. Initialise the system via the  
Speed limit system (compliant  
with the European General Safety  
Regulation)  
This system displays permanently  
speed limit information on the cluster  
independent of the vehicle speed.  
Providing the speed limit information  
involves the following systems,  
depending on version:  
Information Display ðpage58  
Stop at next safe opportunity and check  
tyre pressure.  
4. Reset is confirmed by a message.  
After initialisation the system  
automatically calibrates to new tyre  
pressures during driving. After a longer  
drive the system will adopt and monitor  
new pressures.  
Always check tyre pressure with cold  
tyres.  
The system must be reinitialised when:  
After adjusting tyre pressure initialise the  
system to extinguish the control indicator  
and restart the system.  
If the failure continues to be displayed,  
contact a workshop. The system is  
inoperable when the ABS or Electronic  
Stability Control has a malfunction or a  
temporary spare wheel is used. Once  
the tyre has been refitted, check the tyre  
pressure with cold tyres and initialise the  
system.  
camera at the top of the windscreen  
vehicle's integrated navigation system  
telematics service  
If travelling on a road with no speed  
restrictions, e.g., on German motorways,  
the following sign is displayed:  
Tire pressure has been changed.  
Load condition has been changed.  
Wheels have been swapped or  
Caution  
exchanged.  
Tyre deflation detection system warns  
just about low tyre pressure condition  
and does not replace regular tyre  
maintenance by the driver.  
The system will not warn instantaneously  
on a tyre blow out or a rapid deflation.  
This is due to required calculation time.  
System initialisation  
Traffic Sign Assist (TSA)  
If no speed limit information can be  
provided, the following sign is displayed:  
After tyre pressure correction or wheel  
change, the system must be initialised  
to learn new circumference reference  
values:  
Warning  
The actual traffic sign always takes  
priority over the traffic sign displayed on  
the cluster.  
1. Always ensure that all four tyres have  
correct tyre pressure ðpage170  
2. Apply parking brake.  
If a new speed limit is provided, a  
confirmation chime is given, when the