Vehicle care -> Vehicle checks for Your Vauxhall Insignia 4 Door Second Generation (2018-2022)

230  
Vehicle care  
Vehicle checks  
9 Danger  
Performing work  
The ignition system uses  
extremely high voltage. Do not  
touch.  
Bonnet  
Opening  
Move the safety catch sideways to the  
left vehicle side and open the bonnet.  
The bonnet is held open  
automatically.  
If the bonnet is opened during an  
Autostop, the engine will be restarted  
automatically for safety reasons.  
9 Warning  
Only perform engine compartment  
checks when the ignition is off.  
The cooling fan may start  
operating even if the ignition is off.  
Stop-start system 3 156.  
Closing  
Pull the release lever and return it to  
its original position.  
Lower the bonnet and let it fall into the  
latch from a low height (20-25 cm).  
Check that the bonnet is engaged.  
Vehicle care  
231  
Different dipsticks are used  
depending on engine variant.  
Caution  
Do not press the bonnet into the  
latch to avoid dents.  
Active bonnet 3 71.  
Engine oil  
Check the engine oil level manually  
on a regular basis to prevent damage  
to the engine. Ensure that the correct  
specification of oil is used.  
Recommended fluids and lubricants  
3 277.  
Pull out the dipstick, wipe it clean,  
reinsert fully, pull out and read the  
engine oil level.  
The maximum engine oil  
consumption is 0.6 l per 600 miles.  
Check with the vehicle on a level  
surface. The engine must be at  
operating temperature and switched  
off for at least 5 minutes.  
Caution  
It is the owner's responsibility to  
maintain the proper level of an  
appropriate quality oil in the  
engine.  
232  
Vehicle care  
When the engine oil level has  
dropped to the MIN mark, top up  
engine oil.  
The engine oil level must not exceed  
the MAX mark on the dipstick.  
We recommend the use of the same  
grade of engine oil that was used at  
last change.  
Engine coolant  
The factory filled coolant provides  
freeze protection down to approx.  
-28 °C. In cold regions with very low  
temperatures, the factory filled  
coolant provides frost protection  
down to approx. -37 °C.  
Caution  
Caution  
Only use approved antifreeze.  
Wipe off any spilled engine oil  
immediately.  
If the cooling system is cold, the  
coolant level should be above the  
filling line mark. Top up if the level is  
low.  
Coolant and antifreeze 3 277.  
Coolant level  
Caution  
Caution  
Overfilled engine oil must be  
drained or suctioned out. If the oil  
exceeds the maximum level, do  
not start the vehicle and contact a  
workshop.  
Too low a coolant level can cause  
engine damage.  
Capacities 3 289.  
Fit the cap on straight and tighten it.  
Vehicle care  
233  
Depending on the engine, the  
position of the coolant container may  
be different.  
Washer fluid  
Brakes  
In the event of minimum thickness of  
the brake lining, a squealing noise  
sounds during braking.  
9 Warning  
Continued driving is possible but  
have the brake lining replaced as  
soon as possible.  
Once new brake linings are installed,  
do not brake unnecessarily hard for  
the first few journeys.  
Allow the engine to cool before  
opening the cap. Carefully open  
the cap, relieving the pressure  
slowly.  
To top up, use a 1:1 mixture of  
released coolant concentrate mixed  
with clean tap water. If no coolant  
concentrate is available, use clean  
tap water. Install the cap tightly. Have  
the coolant concentration checked  
and have the cause of the coolant  
loss remedied by a workshop.  
Brake fluid  
Fill with clean water mixed with a  
suitable quantity of approved  
windscreen washer fluid which  
contains antifreeze.  
9 Warning  
Brake fluid is poisonous and  
corrosive. Avoid contact with eyes,  
skin, fabrics and painted surfaces.  
Caution  
Only washer fluid with a sufficient  
antifreeze concentration provides  
protection at low temperatures or  
a sudden drop in temperature.  
Washer fluid 3 277.  
234  
Vehicle care  
Vehicle battery  
Batteries do not belong in household  
waste. They must be disposed of at  
an appropriate recycling collection  
point.  
Laying up the vehicle for more than  
four weeks can lead to battery  
discharge. Disconnect the clamp from  
the negative terminal of the vehicle  
battery.  
Ensure the ignition is switched off  
before connecting or disconnecting  
the vehicle battery.  
The brake fluid level must be between  
the MIN and MAX marks.  
If fluid level is below MIN seek the  
assistance of a workshop.  
The vehicle battery is located in the  
engine compartment.  
There are connecting points for jump  
starting 3 268.  
Brake and clutch fluid 3 277.  
The vehicle battery is maintenance-  
free provided that the driving profile  
allows sufficient charging of the  
battery. Short-distance-driving and  
frequent engine starts can discharge  
the battery. Avoid the use of  
Battery discharge protection 3 138.  
Disconnecting the battery  
If the vehicle's battery is to be  
disconnected (e.g. for maintenance  
work), the alarm siren must be  
deactivated as follows: Switch the  
ignition on then off, then disconnect  
the vehicle's battery within  
unnecessary electrical consumers.  
15 seconds.  
Vehicle care  
235  
The warning message will disappear  
after the engine has been started  
twice without a voltage drop.  
If the vehicle battery cannot be  
recharged, have the cause of the fault  
remedied by a workshop.  
Replacing the vehicle battery  
Notice  
Any deviation from the instructions  
given in this section may lead to  
temporary deactivation or  
disturbance of the stop-start system.  
Charging the vehicle battery  
9 Warning  
On vehicles with stop-start  
system, ensure that the charging  
potential does not exceed 14.6 V  
when using a battery charger.  
Otherwise the vehicle battery may  
be damaged.  
Vehicle battery state of charge  
function  
The function guarantees longest  
vehicle battery life via a generator  
with controllable power output and  
optimised power distribution.  
To prevent discharge of the vehicle  
battery when driving, the following  
systems are reduced automatically in  
two stages and finally switched off:  
When the vehicle battery is being  
replaced, please ensure that there  
are no open ventilation holes in the  
vicinity of the positive terminal. If a  
ventilation hole is open in this area, it  
must be closed off with a dummy cap,  
and the ventilation in the vicinity of the  
negative terminal must be opened.  
Ensure that the battery is always  
replaced by the same type of battery.  
We recommend that you have the  
vehicle battery replaced by a  
workshop.  
Jump starting 3 268.  
Discharge protection  
Battery voltage  
When the vehicle battery voltage is  
running low, a warning message will  
appear in the Driver Information  
Centre.  
auxiliary heater  
heated rear and front window  
heated steering wheel  
heated mirrors  
heated seats  
fan  
1. Switch off any electrical  
consumers which are not required  
for a safe ride, e.g. seat heating,  
heated rear window or other main  
consumers.  
Stop-start system 3 156.  
In the second stage, a message  
which confirms the activation of the  
vehicle battery discharge protection  
will be displayed in the Driver  
Information Centre.  
2. Charge the vehicle battery by  
driving continuously for a while or  
by using a charging device.  
236  
Vehicle care  
Idle boost  
Meaning of symbols:  
Wiper blade replacement  
Windscreen  
If charging of the vehicle battery is  
required due to battery condition, the  
power output of the generator must  
be increased. This will be achieved by  
an idle boost which may be audible.  
No sparks, naked flames or  
smoking.  
Always shield eyes. Explosive  
gases can cause blindness or  
injury.  
A message appears in the Driver  
Information Centre.  
Keep the vehicle battery out of  
reach of children.  
Power outlet  
The vehicle battery contains  
sulphuric acid which could cause  
blindness or serious burn  
injuries.  
The power outlets are deactivated in  
the event of low vehicle battery  
voltage.  
See the Owner's Manual for  
Warning label  
further information.  
Explosive gas may be present in  
the vicinity of the vehicle battery.  
Lift the wiper arm until it stays in the  
raised position. Lift retaining clip to  
disengage the wiper blade and  
remove.  
Attach the wiper blade slightly angled  
to the wiper arm and push until it  
engages.  
Diesel fuel system bleeding  
If the tank has been run dry, the diesel  
fuel system must be bled. Switch on  
the ignition three times for  
15 seconds at a time. Then crank the  
engine for a maximum of  
Lower wiper arm carefully.  
40 seconds. Repeat this process after  
no less than 5 seconds. If the engine  
fails to start, seek the assistance of a  
workshop.