Vehicle care -> Jump starting for Your Vauxhall Vivaro Van Third Generation (2019-2026)

Vehicle care  
273  
Do not disconnect the discharged  
vehicle battery from the vehicle.  
Switch off all unnecessary  
electrical consumers.  
Jump starting  
Do not start with quick charger.  
A vehicle with a discharged vehicle  
battery can be started using jump  
leads and the vehicle battery of  
another vehicle.  
9 Warning  
Avoid contact of the battery with  
eyes, skin, fabrics and painted  
surfaces. The fluid contains  
sulphuric acid which can cause  
injuries and damage in the event  
of direct contact.  
Do not lean over the vehicle  
battery during jump starting.  
Do not allow the terminals of one  
lead to touch those of the other  
lead.  
The vehicles must not come into  
contact with each other during  
the jump starting process.  
Apply the parking brake,  
transmission in neutral,  
automatic transmission in P.  
Caution  
Never expose the vehicle battery  
to naked flames or sparks.  
A discharged vehicle battery can  
already freeze at a temperature  
of 0 °C. Defrost the frozen battery  
before connecting jump leads.  
Wear eye protection and  
protective clothing when  
handling a battery.  
Use a booster battery with the  
same voltage (12 V). Its capacity  
(Ah) must not be much less than  
that of the discharged vehicle  
battery.  
Never jump start another vehicle  
with an electric vehicle.  
9 Warning  
Be extremely careful when starting  
with jump leads. Any deviation  
from the following instructions can  
lead to injuries or damage caused  
by battery explosion or damage to  
the electrical systems of both  
vehicles.  
Use jump leads with insulated  
terminals and a cross section of  
at least 16 mm2 (25 mm2 for  
diesel engines).  
274  
Vehicle care  
Open the positive terminal protection  
caps of both vehicle batteries.  
Lead connection order:  
1. Connect the red lead to the  
positive terminal of the booster  
battery.  
2. Connect the other end of the red  
lead to the positive terminal of the  
discharged battery.  
3. Allow both engines to idle for  
approx. three minutes with the  
leads connected.  
4. Switch on electrical consumers  
e.g. headlights, heated rear  
window of the vehicle receiving  
the jump start.  
Towing  
Towing the vehicle  
5. Reverse above sequence exactly  
when removing leads.  
3. Connect the black lead to the  
negative terminal of the booster  
battery.  
4. Connect the other end of the black  
lead to a vehicle grounding point  
of your vehicle in the engine  
compartment.  
Route the leads so that they cannot  
catch on rotating parts in the engine  
compartment.  
Press in the middle of the cover plate  
and slide to the upper left corner to  
unclip it.  
The towing eye is stowed with the  
vehicle tools 3 257.  
To start the engine:  
1. Start the engine of the vehicle  
providing the jump.  
2. After 5 minutes, start the other  
engine. Start attempts should be  
made for no longer than 15  
seconds at an interval of 1 minute.