242
Vehicle care
6. Close the bonnet.
Lower the wiper arm carefully.
Rear window
Engines DW10FEU, DW10FD,
DW10FDCU, DW10F
1. Switch on the ignition.
Wiper blade replacement
2. Wait 6 seconds and switch off the
ignition.
Windscreen
3. Repeat steps 1 and 2 for ten times.
4. Try to start the engine.
If the engine does not start after a
short time, repeat the procedure.
Engine DV6DU
1. Open the engine bonnet.
2. If necessary, unclip the engine
style cover to access the priming
pump.
3. Operate the priming pump
repeatedly until resistance is felt
(there may be resistance at the first
press).
4. Try to start the engine. If the engine
does not start after a short time, wait
around 15 seconds before trying
again. If the engine does not start
after a few attempts, repeat step 3
and try again to start the engine.
Lift the wiper arm. Disengage the
wiper blade as shown in the
illustration and remove.
Attach the wiper blade slightly angled
to the wiper arm and push until it
engages.
Switch off the ignition.
Within 1 minute after switching off the
ignition, operate the wiper lever to
positon the wiper blades vertically on
the windscreen.
Lift the wiper arm until it stays in the
raised position, disengage and
remove the wiper blade.
Lower the wiper arm carefully.
Attach the wiper blade to the wiper
arm and push until it engages.
5. Put the engine style cover in place
and clip it in.
English 
