Golf Variant 2007 ➤ , Golf Variant 2010 ➤ , Jetta 2005 ➤ , Jetta 2011 ➤
6-Speed Manual Transmission 02Q - Edition 05.2013
8
Transmission Fluid, Checking
Special tools and workshop equipment required
♦ Torque Wrench 1331 5-50Nm - VAG1331-
♦ Triple Square Socket Driver - 3357-
♦ Used Oil Collection and Extraction Unit - SMN372500-
Transmission fluid specification. Refer to the Parts Catalog.
– Remove the noise insulation. Refer to ⇒ Body Exterior; Rep.
Gr. 50 ; Noise Insulation .
– Place the Used Oil Collection and Extraction Unit -
SMN372500- under the transmission.
– Remove the plug for checking the transmission fluid level
-arrow-.
The level is correct when the transmission fluid comes up to the
bottom edge of oil filler hole.
– Install the plug -arrow- with a new seal.
– Tighten the plug -arrow- to the tightening specification. Refer
to
⇒ Fig. ““Different Versions of the Oil Fill and Drain Plugs”“ ,
page 192 .
Note the Following when Filling for the First Time
– Remove the plug -arrow-.
– Add transmission fluid until it reaches the lower edge of the
filler hole.
– Install the plug -arrow- with a new seal.
– Tighten the plug -arrow- to the tightening specification. Refer
to
⇒ Fig. ““Different Versions of the Oil Fill and Drain Plugs”“ ,
page 192 .
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
50 ; Noise Insulation .
Different Versions of the Oil Fill and Drain Plugs
I - Oil filler or drain plug with multi-point socket head, 45 Nm
II - Oil filler or drain plug with hex socket head, 30 Nm
192
Rep. Gr.34 - Operation and Housing
English 
