Safety belts -> Using safety belts for Your Volkswagen Jetta 4 Door Seventh Generation (2019-2025)

Fig. 23 In the instrument cluster display: warning light for the fasten seat belts reminder.  
The driver or front passenger has not fastened their safety belt. Fasten all safety belts.  
When the ignition is switched on, several warning and indicator lamps light up temporarily as a function check. They then turn  
off after a few seconds.  
A chime also sounds.  
When the ignition is switched on, the red  
warning light comes on for six seconds. A chime also sounds for up to six second  
if the driver safety belt is not fastened. The chime ends when the driver fastens their safety belt. The warning lamps and chime  
go off when the driver and front passenger have fastened their safety belts.  
If the driver and front passenger do not both fasten their safety belts within 10 seconds after the warning chime has ended an  
the vehicle is driving at a speed above approx. 25 km/h (approx. 15 mph), the chime sounds again for approx. 6 seconds, the  
stops for approx. 24 seconds, and then sounds again for approx. 6 seconds. The same happens if one of the safety belts is  
released while driving. The red  
warning light comes on. A warning chime also sounds for up to two minutes at 24-second  
intervals. The chime does not sound at speeds below approx. 8 km/h (approx. 5 mph).  
When the ignition is switched on, the red  
their safety belts.  
warning light comes on until the driver and front passenger have both fastened  
WARNING  
The risk of serious and fatal injuries increases if the safety belts are not worn or are worn incorrectly.  
Fasten the safety belts and use them correctly to ensure that they provide optimum protection.  
Using safety belts  
Please read the introductory information and heed the Warnings and Notice   
Introduction.  
Checklist  
Using safety belts  
:
Check the condition of all of the safety belts regularly.  
Keep safety belts clean.  
Always keep foreign objects and fluids far away from the safety belt, the safety belt buckle, and the slot in the safety be  
52  
buckle.  
Do not pinch or damage the safety belt and/or belt buckle, for example closing it in a door.  
Never remove, modify, or repair the safety belt and belt fastening elements.  
Always fasten the safety belt correctly before you begin driving and keep it fastened while driving.  
Twisted safety belt  
If the safety belt is difficult to pull out of the belt guide, the safety belt may have been pulled out too quickly when positioning  
the belt and may have become twisted within the side trim panel:  
1. Slowly and carefully pull the safety belt out completely by the belt buckle.  
2. Untwist the safety belt and guide the safety belt back slowly by hand.  
If you cannot untwist the safety belt, fasten the safety belt anyway. The twist must not be in a belt area that lies directly agains  
the body. Contact an authorized Volkswagen dealer or authorized Volkswagen Service Facility immediately to have the twist  
rectified. Volkswagen recommends contacting an authorized Volkswagen dealer or authorized Volkswagen Service Facility.  
Lockable safety belt  
The safety belts on the rear seats and the safety belt on the front passenger seat are lockable and have an emergency lockin  
function. With the locking function, you can adjust the safety belt so that a child restraint is properly installed Securing a  
child restraint with a safety belt.  
Safety belts may only be locked for certain child restraint systems Child restraints – overview.  
An activated locking mechanism must be released when a vehicle occupant fastens their safety belt. To release the lock, push  
the red button in the belt buckle and guide the seat belt back fully by hand.  
WARNING  
Incorrect handling of the safety belts increases the risk of severe or fatal injuries.  
Check the safety belts and associated components regularly to ensure they function correctly.  
Never attempt to repair safety belts. Have damaged safety belts replaced.  
Always keep the safety belts clean.  
Never damage the safety belts by trapping them or chafing them on sharp edges.  
Always keep the belt buckle and insertion guide for the belt buckle free of foreign objects and fluids.  
Fastening and unfastening the safety belts  
Please read the introductory information and heed the Warnings and Notice ⇒  
Introduction.  
Safety belts that are fastened correctly hold vehicle occupants in the correct position during braking maneuvers or in a  
collision, in order to provide the maximum protection ⇒  
.
Fastening the safety belt  
53