Advertisement

Advertisement

Checking battery -> 2.8 Checking no-load voltage of battery on stock and stored vehicles for Your Volkswagen Sharan VAN First Generation (1995-2010)

lk  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
Test requirements  
♦ When charging a battery, battery temperature must be at least  
≥ +10 °C.  
♦ The charger must be capable of outputting a charge current of  
at least 30 A, as for example with VAS 5095A, VAS 5900, VAS  
5903  
♦ The battery's current draw must be measured with a current  
pick-up clamp, e.g. VAS 5051B/7, when charging with battery  
charger -VAS 5095A- . Battery charger -VAS 5900- and bat‐  
tery charger -VAS 5903- display the current draw on the unit.  
– Connect battery to battery charger and start charging se‐  
quence.  
– Measure charging current of battery after 5 minutes.  
Test result:  
If the current draw A is higher than 10 % of the nominal capacity  
(e.g. > 6.1 A for a 61 Ah battery), fully charge battery and test  
again.  
Note  
For Eos with two 6V absorbent glass mat batteries, the charge  
current must only be 5 % higher than the nominal capacity of the  
battery. Example for Eos: the 50 Ah battery must have a charge  
current higher than 2.5 A after 5 minutes of starting the charging  
sequence.  
– Fully charge the battery when the charge current is higher than  
10 % of the nominal capacity (observe exception for Eos in  
above note).  
– Perform battery test after allowing battery to rest for two hours  
⇒ page 9 .  
If the charge current, in amperes, lies below 10 % of the nominal  
capacity after 5 minutes of starting the charging sequence (5 %  
for the 2 x 6 volt batteries in Eos) (example for 50 Ah battery <  
5A), renew battery. For Guarantee and ex-gratia cases: complete  
battery test sheet and keep it with the battery.  
2.8  
Checking no-load voltage of battery on  
stock and stored vehicles  
WARNING  
Danger of injury! Observe warning notices and safety regula‐  
tions ⇒ page 2 !  
Note  
The no-load voltage test may only be carried out to assess the  
condition of the battery on stock and stored vehicles within the  
framework of prescribed maintenance.  
The no-load test serves to determine whether a battery on a  
stock or stored vehicle requires recharging ⇒ Maintenance  
tables „Service for stock and stored vehicles“ .  
Special tools and workshop equipment required  
2. Checking battery  
23  
Bora 1999 ➤ , Bora Variant 1999 ➤ , CC 2010 ➤ , Eos 2006 ➤ , Golf 199 ...  
Electrical System, General Information - Edition 07.2010  
♦ Hand multimeter -V.A.G 1526 B-  
Test conditions  
The battery must not have been charged or discharged within the  
last 2 days.  
– Check battery no-load voltage with hand multimeter -V.A.G  
1526 B- .  
No-load voltage  
11.60 V  
Charge  
0 %  
Condition of battery  
Discharged, no capacity Heavily discharged ⇒ page 59 .  
lk  
Measured value  
Measure to be performed  
No-load voltage ≥ 12.5 V  
No-load voltage < 12.5 V  
No-load voltage OK  
Charging battery ⇒ page 25  
24  
Rep. gr.27 - Starter, current supply, CCS