Advertisement

Advertisement

Wheels -> Wheel bolt cover caps for Your Volkswagen T Cross SUV First Generation (2018-2025)

Store the tyre pressure values in the infotainment  
Applies to 10Infotainment:  
— Continue driving, exercising appropriate caution,  
and seek the help of a specialist garage.  
In the following menu, select the menu item for dis-  
playing the vehicle condition:  
— Tap on  
.
Wheel bolt cover caps  
— By moving your finger sideways, choose the  
screen with the menu item for the vehicle status.  
Remove cover caps and install  
— Select the menu item for the vehicle status.  
— Select the menu item for the tyres.  
Disconnecting  
— Press the  
button.  
— Then follow the instructions on the screen.  
In which case the tyre pressure values are to be  
stored  
— Change of tyre pressure  
— Change of one or more wheels  
— Change of position of a wheel on the vehicle  
— Always after covering a distance of 10,000 km or  
once a year  
— Insert the bracket from the tool kit into the recess  
in the cover cap.  
Sticker for storing the tyre pressure values  
— Remove the cover cap.  
The procedure for storing the tyre pressure values is  
also shown on a sticker. It is located on the centre  
body pillar on the driver's side.  
Installing  
— Push the cover cap onto the wheel bolt to the  
stop.  
Full wheel frame  
Removing and installing the trim  
Applies to factory built or original accessory trims  
from Volkswagen.  
Disconnecting  
1
2
Inflating the tyre to the prescribed inflation  
pressure  
— Hang the clamps for removing the wheel trims at  
the edge of one of the openings in the trim.  
Saving the values  
— Push the wheel wrench through the clamp, sup-  
port on the tyre and pull off the wheel trim.  
Installing  
Troubleshooting  
— Press the wheel trim onto the wheel rim at the  
designated valve opening.  
Functional restriction / system fault  
When using an anti-theft wheel bolt, it must be  
located at the location indicated on the bezel.  
flashes for about 1 minute and stays on  
— Stop the vehicle, switch off the ignition  
and start the engine.  
— Press the trim, starting at the valve, into the rim  
on both sides until it engages around the entire  
circumference.  
If the indicator light  
flashes again after  
starting the engine, there is a system error.  
Wheel bolt cover caps  
117