2019-2025 Audi RS6 4 Door Checking and topping up fluids -> Electrical system User Manual
MyCarUserManual.com
USER MANUALS FOR EVERY MAKE & MODEL

Checking and topping up fluids -> Electrical system for Your Audi RS6 4 Door Fourth Generation (2019-2025)

Checking and topping up fluids  
front and rear longitudinal edges until all tabs  
engage.  
Driver messages about the brake system  
The following driver messages may appear, de-  
pending on the equipment installed in your vehi-  
cle:  
The brake fluid level is also automatically moni-  
tored.  
Having the brake fluid changed  
Brakes: stop vehicle and check brake fluid  
level  
The brake fluid is changed at regular intervals.  
Have the brake fluid changed by a qualified work-  
shop. The qualified workshop will inform you of  
these intervals.  
Stop the vehicle and check the brake fluid level.  
Seek professional assistance.  
WARNING  
WARNING  
If the brake fluid level is under the MIN mark,  
the effectiveness of the brakes and therefore  
the safety of the vehicle may be impaired –  
risk of accident! Do not drive on. Seek profes-  
sional assistance.  
Please refer to the safety information ð  
in Driver messages about the brake system  
on page 244.  
Heavy use of the brakes may cause a vapour  
lock if old brake fluid is left in the system.  
This would seriously impair the effective-  
ness of the brakes and the safety of the car –  
risk of accident!  
CAUTION  
If the brake fluid level is above the MAX mark,  
brake fluid may escape via the cap on the res-  
ervoir in certain circumstances and cause  
damage to the vehicle.  
The brake fluid in your vehicle must comply  
with the VW 501 14 standard. If this brake  
fluid is not available, it is permissible to use  
an alternative high-quality brake fluid com-  
plying with the U.S. Federal Motor Vehicle  
Standard (FMVSS) 116 DOT 4, Class 6  
(ISO 4925).  
Electrical system  
Driver messages about the electrical  
system  
If used brake fluid or brake fluid not ap-  
proved for your vehicle is used, the effective-  
ness of the brakes will be seriously impaired  
and the brake system could even fail com-  
pletely – risk of accident! The vehicle manu-  
facturer will accept no liability for faults or  
damage which occur as a result. In addition,  
no warranty claims will be accepted.  
The following driver messages may appear, de-  
pending on the equipment installed in your vehi-  
cle:  
If the warning lamp  
/
lights up, there is a  
power supply or battery fault or a fault in the ve-  
hicle's electrical system.  
Electrical system: fault. Safely stop vehicle  
CAUTION  
The steering wheel may also vibrate when the  
driver message appears. Stop the vehicle safely  
and do not continue driving. You should also  
switch off the vehicle ð . Seek professional as-  
sistance.  
Please refer to the safety information ð  
in Driver messages about the brake system  
on page 244.  
Brake fluid must not be allowed to come in-  
to contact with the vehicle's body, other-  
wise it will attack the paintwork.  
Electrical system: fault. No restart possible.  
Please contact workshop  
244  
Checking and topping up fluids  
It will not be possible to restart the vehicle once  
you have switched it off. The performance of cer-  
tain vehicle functions may be limited and the ve-  
hicle’s handling may be impaired. Drive to a  
qualified workshop without delay.  
the electrical equipment is powered back or  
switched off. Certain convenience features, such  
as interior lighting or electric seat adjustment,  
may not be available. These functions will be re-  
stored when you activate the drive system.  
Electrical system: fault. Please contact  
Even though some systems are deactivated auto-  
matically, certain electrical equipment continues  
to draw current even when the ignition is off. If  
the vehicle is left standing for long periods, this  
can result in total 12-volt battery discharge. If  
the vehicle battery is allowed to discharge com-  
pletely, an internal chemical reaction damages  
the battery irreparably. To avoid this, the battery  
should be recharged at least once a month  
ðpage 247. Please seek advice from a qualified  
workshop.  
workshop  
Switch off any electrical equipment which is not  
required (some equipment may be switched off  
automatically). The performance of certain vehi-  
cle functions may be limited and the vehicle’s  
handling may be impaired. Drive to a qualified  
workshop without delay.  
Electrical system: low battery charge. Bat-  
tery will be charged while driving  
If this message disappears after a while, the ve-  
hicle battery will have been sufficiently charged  
while driving.  
Winter conditions  
Cold weather is very hard on the 12-volt vehicle  
battery. For this reason, you should have the bat-  
tery checked by a qualified workshop before the  
start of winter.  
If the message does not disappear again, drive  
to a qualified workshop and have the fault rec-  
tified.  
Replacing the battery  
WARNING  
The following description applies to the 12-volt  
vehicle battery. Any work on the battery must al-  
ways be carried out by a qualified workshop.  
An electrical system fault can cause vehicle  
functions to fail, thus impairing the vehicle’s  
stability – risk of accident! Switch the vehicle  
off and do not drive on. Seek professional as-  
sistance.  
The 12-volt vehicle battery has been developed  
for use in its installation location and is equipped  
with safety features. If a 12-volt vehicle battery  
has to be replaced, please enquire about the  
electromagnetic compatibility, capacity and the  
required maintenance, performance and safety  
features of the new 12-volt vehicle battery be-  
fore purchasing it from your qualified workshop.  
The gas vent on the 12-volt vehicle battery must  
always be located on the side of the negative ter-  
minal. The gas vent on the side of the positive  
terminal must always be sealed.  
Battery  
Information on batteries  
Because of the complexity of the power supply,  
any battery work, such as disconnection, replace-  
ment, etc. must be carried out by a qualified  
workshop ð  
.
Several batteries using different technologies are  
fitted in your vehicle:  
When replacing the 12-volt lead battery, use only  
maintenance-free 12-volt lead batteries to  
standards TL 825 06 and VW 7 50 73. These  
standards must be from October 2014 or later.  
12-volt vehicle battery (e.g. for basic supply)  
ðpage 246, Safety information on batteries  
If the vehicle is not used for long periods  
WARNING  
The 12-volt battery gradually becomes dis-  
charged if the vehicle is left standing for long pe-  
riods. To ensure that the vehicle can be started,  
Any work on the batteries and electrical sys-  
tem in your vehicle entails a risk of injury  
245  

Related Topics

Popular Owner Manuals