Mobility
The tyre repair kit must NOT be used:
Note
– On cuts and punctures larger than 4 mm
ðFig. 212.
1
– If sealant should leak out, leave it to dry.
When it has dried, you can pull it off like a
piece of foil.
– If the wheel rim has been damaged 2 .
– If you have been driving with very low pressure
or a completely flat tyre 3 .
– Please note the expiry date on the tyre seal-
ant container. If necessary, have the tyre
sealant replaced by a qualified workshop.
– Interference to the radio reception may oc-
cur when using the compressor.
In this case, you should seek professional assis-
tance.
WARNING
– Always adhere to the locally applicable laws
and regulations.
– Please note that the tyre repair kit is not
suitable for use in every situation and
should only be used as a temporary meas-
ure.
Tyre repairs
Applies to: vehicles with tyre repair kit
– Do not allow the sealant to come into con-
tact with your eyes, skin or clothing.
– If you do come into contact with the sealant
immediately rinse the eyes or skin affected
with clean water.
– Make sure you do not breathe in the fumes.
– If you accidentally swallow tyre sealant, im-
mediately rinse your mouth thoroughly and
drink a large amount of water. Do not in-
duce vomiting. Seek medical assistance im-
mediately.
Fig. 213 Components of the tyre repair kit
– Change clothing immediately if it becomes
soiled with the tyre sealant.
– If any allergic reactions should occur, seek
medical assistance immediately.
– Keep the sealant away from children.
– After using the tyre sealant the tyre pres-
sure monitoring system* may malfunction
or display incorrect values. Therefore, please
drive carefully to the next available qualified
workshop.
Fig. 214 Connecting the tyre repair kit
Important: The tyre repair kit must be at hand
and ready for use ðpage 353.
For the sake of the environment
Batteries and electric/electronic equip-
ment must be disposed of appropriately
ðpage 381, Information on waste disposal.
Setting up the tyre repair kit
►
If necessary, remove the “max. 80 km/h” stick-
er from the socket on the compressor.
►
Take the connector 3 and the compressor hose
4 out from the bottom of the housing.
354