38nAlarm system
The concept
Arming and disarming alarm
system
The vehicle alarm system responds:
When you lock or unlock the vehicle,
either with the remote control or at the
door lock, the alarm system is armed or
disarmed at the same time.
> When a door, the hood, or the liftgate
is opened
> To movement in the vehicle interior:
interior protection, refer to Tilt alarm
sensor and interior motion sensor
> To variations in the vehicle tilt angle
such as occur during attempts to
steal the wheels or tow the vehicle
> To interruption of battery voltage.
You can have different acknowl-
edgment signals set to confirm
arming and disarming.<
The system responds to unauthorized
vehicle entry and attempted theft by
simultaneously activating the following:
Indicator lamp displays
The liftgate can also be opened with the
system armed using the button on the
remote control, refer to page 31. The
liftgate is locked again when closed.
Pressing the button longer triggers the
alarm: panic mode, refer to page 32.
> The indicator lamp below the interior
rearview mirror flashes continuously:
the system is armed
> Sounding an acoustical alarm for
30 seconds
> The hazard warning flashers are acti-
vated for approx. five minutes
> The high beams flash on and off in
the same rhythm.
> The indicator lamp flashes when the
vehicle is locked: door(s) or liftgate
are not completely closed. Even if
you do not close the alerted area, the
system begins to monitor the remain-
ing areas, and the indicator lamp
flashes continuously after 10 sec-
onds. However, the interior motion
sensor is not activated
> The indicator lamp goes out when the
vehicle is unlocked: no manipulation
or attempted intrusions have been
detected in the period since the sys-
tem was armed
English 
