146  
					Lighting  
					Entry lighting can be disabled manually by  
					closing all doors, pressing Q on the remote  
					key, or starting the vehicle.  
					Battery Load Management  
					The vehicle has Electric Power Management  
					(EPM), which estimates the battery's  
					temperature and state of charge. It then  
					adjusts the voltage for best performance  
					and extended life of the battery.  
					This feature can be changed. On the  
					infotainment home page, select Settings T  
					Vehicle T Vehicle Locator Lights.  
					When the battery's state of charge is low,  
					the voltage is raised slightly to quickly bring  
					the charge back up. When the state of  
					charge is high, the voltage is lowered  
					slightly to prevent overcharging. The  
					voltmeter gauge or the voltage display on  
					the Driver Information Center (DIC),  
					if equipped, may show the voltage moving  
					up or down. This is normal. If there is a  
					problem, an alert will be displayed.  
					Exit Lighting  
					Some exterior lamps and interior lamps turn  
					on when the driver door is opened after the  
					vehicle is turned off.  
					Press the lamp lens to turn the rear reading  
					lamps on or off.  
					Lighting Features  
					The exterior and interior lamps remain on  
					for a set amount of time, then automatically  
					turn off.  
					Entry Lighting  
					The interior lamps turn on when pressing K  
					on the remote key or opening any doors,  
					and the dome lamp control is in the door  
					position.  
					The interior lights turn on when the vehicle  
					is turned off.  
					The battery can be discharged at idle if the  
					electrical loads are very high. This is true for  
					all vehicles. This is because the generator  
					(alternator) may not be spinning fast  
					enough at idle to produce all the power that  
					is needed for very high electrical loads.  
					The exterior lamps turn off immediately by  
					turning the exterior lamp control off.  
					Some exterior lamps also turn on when  
					This feature can be changed. On the  
					infotainment home screen, select Settings T  
					Vehicle T Exit Lighting.  
					pressing K on the remote key or opening  
					any doors. Low-Beam lamps will only turn  
					on briefly at night, or in areas with limited  
					lighting.  
					A high electrical load occurs when several of  
					the following are on, such as: headlamps,  
					high beams, fog lamps, rear window  
					All lamps will gradually fade out after about  
					30 seconds.  
					defogger, climate control fan at high speed,