Driving
Switching off
Operating faults
The vehicle can be stopped whatever the
position of the gear selector (N, E or R).
However, there is an audible signal on opening
the driver's door if the gear selector is not at
position N.
In all cases, it is essential that you
apply the parking brake to immobilise
the vehicle.
With the ignition on, illumination
of this warning lamp indicates a
gearbox fault.
Contact a CITROËN dealer or a
qualified workshop.
When the vehicle is stopped with the
engine running, always put the gear
selector to neutral N.
Before doing anything under the
bonnet, check that the gear selector is
in neutral N and the parking brake is
applied.
If N is flashing in the instrument panel
accompanied by an audible signal for a long time:
-
check that the ignition switch is at the
"ON" position,
-
place the gear selector at N, then move it
to E, M or R.
There is a continuous audible signal
if you turn the ignition switch to "OFF"
with the vehicle in 2nd, 3rd, 4th or 5th gear.
In this case return the ignition switch
to "ON", move the gear selector to
position N, then to position E, M or R,
then turn the ignition switch to "OFF".
If 1 is flashing in the instrument panel:
-
Limits of operation
place the gear selector at E or M, then
move it to N.
On a gradient, or when hill start assist is
activated, never hold the vehicle using the
accelerator: you could damage the clutch.
In these situations there is an audible signal.
If R is flashing in the instrument panel:
-
place the gear selector at R, then move it
to N.
F
F
Move the gear selector to position N.
Wait 15 minutes to allow the clutch to cool
down before setting off.
On a slope, use the brakes to
immobilise the vehicle and place the
gear selector in position N, E or R.
80
English 